Channel characterization and modeling for large-scale antenna systems

In light of the emerging fifth generation (5G) mobile communications, large-scale antenna systems (LSAS, also known as large-scale MIMO, massive MIMO, etc.) present a highly promising solution to meet the demanding requirements of even higher network capacity, throughput, spectrum- and energy-efficiency than 4G systems. Channel measurements show that unlike conventional MIMO, quite a few new channel characteristics need to be taken into consideration when modelling the LSAS. Employing appropriate channel models is critically important not only for the performance evaluation of different candidate 5G technologies, but also for the development of new algorithms and products exploiting the LSAS. This paper presents the current progress on channel characterization of LSAS and discusses the major open issues. The key differentiating channel characteristics of LSAS (e.g., non-stationarity, near-field effects, etc.) are summarized, which poses new challenges to channel modeling as well as systems design and network simulation for LSAS. In order to develop comprehensive channel models for LSAS, further investigation through thorough field measurement and validation is necessary to reveal the channel characteristics of LSAS operating in various deployment scenarios with different antenna configurations.

[1]  Stephan ten Brink,et al.  Channel measurements for large antenna arrays , 2012, 2012 International Symposium on Wireless Communication Systems (ISWCS).

[2]  Cheng-Xiang Wang,et al.  A Non-Stationary 3-D Wideband Twin-Cluster Model for 5G Massive MIMO Channels , 2014, IEEE Journal on Selected Areas in Communications.

[3]  Josef A. Nossek,et al.  On the condition number distribution of complex wishart matrices , 2010, IEEE Transactions on Communications.

[4]  Claude Oestges,et al.  The COST 2100 MIMO channel model , 2011, IEEE Wirel. Commun..

[5]  Erik G. Larsson,et al.  Scaling Up MIMO: Opportunities and Challenges with Very Large Arrays , 2012, IEEE Signal Process. Mag..

[6]  Erik G. Larsson,et al.  Massive MIMO for next generation wireless systems , 2013, IEEE Communications Magazine.

[7]  Xuefeng Yin,et al.  Massive MIMO Channel Models: A Survey , 2014 .

[8]  Thomas L. Marzetta,et al.  Noncooperative Cellular Wireless with Unlimited Numbers of Base Station Antennas , 2010, IEEE Transactions on Wireless Communications.

[9]  Fredrik Tufvesson,et al.  Delay spread properties in a measured massive MIMO system at 2.6 GHz , 2013, 2013 IEEE 24th Annual International Symposium on Personal, Indoor, and Mobile Radio Communications (PIMRC).

[10]  Guidelines for evaluation of radio interface technologies for IMT-Advanced , 2008 .

[11]  K. Borner,et al.  Channel modelling for the fifth generation mobile communications , 2014, The 8th European Conference on Antennas and Propagation (EuCAP 2014).

[12]  Fredrik Tufvesson,et al.  Massive MIMO channels — Measurements and models , 2013, 2013 Asilomar Conference on Signals, Systems and Computers.

[13]  Weiwei Jiang.  Implementation of the COST 2100 MIMO Channel Model in C + + / IT + + , .

[14]  Thomas L. Marzetta,et al.  Multiple-antenna channel hardening and its implications for rate feedback and scheduling , 2004, IEEE Transactions on Information Theory.