Acceleration charge sensitivity in AT-quartz resonators

The behavior of AT-quartz resonators subject to acceleration is studied. For an AT-strip resonator with cantilever mounting, piezoelectric theory predicts that excitation of the pure lowest frequency flexural mode of vibration generates no charge. However, experiments show electromechanical resonance corresponding to this mode for sinusoidal support motion normal to the plane of the crystal with no applied electric field. An amplifier with a voltage follower first stage senses charge output from the crystal. Shielding is required to reduce sixty hertz and drive frequency electromagnetic interference. Measurement of resonant frequency and damping factor for the lowest frequency flexural mode is reported for a group of 17.76 MHz oscillator crystals. This mode is responsible for crystal breakage in some portable communications products. Significant variation in sensitivity among crystals was observed. Charge sensitivity of this mode is attributed in part to mechanical coupling to other modes involving torsion and lateral flexure.

[1]  H. F. Tiersten,et al.  Linear Piezoelectric Plate Vibrations , 1969 .

[2]  J. Wang,et al.  Vibrations of AT-cut quartz strips of narrow width and finite length , 1992, Proceedings of the 1992 IEEE Frequency Control Symposium.

[3]  R. L. Filler.  The acceleration sensitivity of quartz crystal oscillators: a review , 1988 .

[4]  Pcy Lee,et al.  A Two-Dimensional Theory for High-Frequency Vibrations of Piezoelectric Crystal Plates with or Without Electrodes , 1986, IEEE 1986 Ultrasonics Symposium.

[5]  J. Soderkvist.  An analysis of space-dependent electric fields used in exciting flexural vibrations of piezoelectric beams , 1990 .

[6]  J. A. Kosinski,et al.  Advances in acceleration sensitivity measurement and modeling , 1992, Proceedings of the 1992 IEEE Frequency Control Symposium.

[7]  Raymond D. Mindlin,et al.  Thickness‐Shear and Flexural Vibrations of Crystal Plates , 1951 .

[8]  R. M. Langdon,et al.  Resonator sensors-a review , 1985 .

[9]  J. Söderkvist.  An equivalent circuit description of two coupled vibrations , 1991 .

[10]  G. Kino.  Acoustic waves : devices, imaging, and analog signal processing , 1987 .

[11]  H. Bahadur,et al.  2 – Acoustic Vibrational Modes in Quartz Crystals: Their Frequency, Amplitude, and Shape Determination , 1982 .

[12]  H. F. Tiersten,et al.  Perturbation theory for linear electroelastic equations for small fields superposed on a bias , 1978 .

[13]  R.C. Smythe.  Acceleration effects in crystal filters-a tutorial , 1992, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[14]  P. C. Lee,et al.  Piezoelectric Crystals and Electro-elasticity , 1974 .

[15]  E. P. Eernisse,et al.  Survey of quartz bulk resonator sensor technologies , 1988, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[16]  Stephen P. Timoshenko,et al.  Vibration problems in engineering , 1928 .

[17]  J. Söderkvist.  Dynamic behavior of a piezoelectric beam , 1991 .

[18]  J. Soderkvist.  Electric equivalent circuit for flexural vibrations in piezoelectric materials , 1990, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[19]  L. Dworsky,et al.  Analysis and Design of Coupled Mode AT Rectangular Resonators , 1984 .

[20]  M.M. Driscoll.  Quartz crystal resonator g sensitivity measurement methods and recent results , 1990, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[21]  R. D. Weglein,et al.  Acceleration, vibration and shock effects-IEEE standards Project P1193 , 1992, Proceedings of the 1992 IEEE Frequency Control Symposium.

[22]  R. Bechmann,et al.  Elastic and Piezoelectric Constants of Alpha-Quartz , 1958 .

[23]  V. E. Bottom.  Introduction to Quartz Crystal Unit Design , 1982 .

[24]  R. F. Mitchell,et al.  Generation and Detection of Sound by Distributed Piezoelectric Sources , 1970 .