Spring Inserts for the Intensification of the Heat Exchange Process during Boiling in Vertical Tubes—Optimization of Geometric Parameters
暂无分享,去创建一个
[1] Jinxing Wu,et al. Numerical study on heat transfer and flow characteristics of a tube fitted with double spiral spring , 2015 .
[2] J. San,et al. Experimental investigation on heat transfer and fluid friction correlations for circular tubes with coiled-wire inserts , 2015 .
[3] B. Niezgoda-Żelasko,et al. Refrigerant boiling at low heat flux in vertical tubes with heat transfer enhancing fittings , 2015 .
[4] B. Niezgoda-Żelasko,et al. Free and forced convection on the outer surface of vertical longitudinally finned tubes , 2014 .
[5] J. San,et al. Boiling heat transfer characteristics in a horizontal tube with internal helical threads and that with a fin-module insert , 2013 .
[6] Aydın Durmuş,et al. Heat transfer and exergy loss in conical spring turbulators , 2013 .
[7] Enio Pedone Bandarra Filho,et al. Experimental study of the effect of twisted-tape inserts on flow boiling heat transfer enhancement and pressure drop penalty , 2013 .
[8] Eyuphan Manay,et al. A Taguchi approach for optimization of design parameters in a tube with coiled wire inserts , 2011 .
[9] Soon-Heung Chang,et al. Swirl flow analysis in a helical wire inserted tube using CFD code , 2010 .
[10] Orhan Büyükalaca,et al. The experimental investigation of heat transfer and pressure drop in a tube with coiled wire inserts placed separately from the tube wall , 2010 .
[11] Pongjet Promvonge,et al. Influence of combined non-uniform wire coil and twisted tape inserts on thermal performance characteristics ☆ , 2010 .
[12] M. Akhavan-Behabadi,et al. Heat transfer and pressure drop characteristics of forced convective evaporation in horizontal tubes with coiled wire inserts , 2009 .
[13] M. Salimpour,et al. Pressure drop increase of forced convective condensation inside horizontal coiled wire inserted tubes , 2008 .
[14] Soon Heung Chang,et al. Flow-induced vibration in two-phase flow with wire coil inserts , 2008 .
[15] J. Chung,et al. Flow boiling heat transfer characteristics of nitrogen in plain and wire coil inserted tubes , 2007 .
[16] V. Zimparov,et al. Performance Evaluation of Some Tube Inserts as Heat Transfer Enhancement Techniques , 2006 .
[17] T. H. Ko,et al. Thermodynamic analysis of optimal curvature ratio for fully developed laminar forced convection in a helical coiled tube with uniform heat flux , 2006 .
[18] J. S. Lee,et al. Heat transfer and internal flow characteristics of a coil-inserted rotating heat pipe , 2001 .
[19] Anil Kumar,et al. Heat transfer augmentation by coiled wire inserts during forced convection condensation of R-22 inside horizontal tubes , 1998 .
[20] Adrian Bejan,et al. Method of entropy generation minimization, or modeling and optimization based on combined heat transfer and thermodynamics , 1996 .
[21] S. Kandlikar. A General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes , 1990 .
[22] D. Chisholm,et al. Two-phase flow in heat exchangers and pipelines , 1985 .