Musculotendon parameters and musculoskeletal pathways within the human foot.

In order to create a flexible model of the foot for dynamic musculoskeletal models, anthropometric data combined with geometric information describing the intrinsic musculature are needed. In this study, the left feet of two male and two female cadavers were dissected to expose the intrinsic musculotendon pathways. Three-dimensional coordinates of bony landmarks, tendon origins, insertions, and via points were digitized to submillimeter accuracy. Muscle architectural parameters were also measured, including volume, weight, and pennation angle and sarcomere, fascicle, and free tendon lengths. Optimal muscle fascicle lengths, pen-nation angles at optimal length, physiological cross-sectional areas (PCSA), and tendon slack lengths were calculated from the directly measured values. Fascicle length and pennation angle varied greatly within each subject. Average fascicle lengths normalized by optimal fascicle length varied between 0.73 and 1.25, with 75% of the formalin-preserved muscles being found in a shortened state. The muscle volume and PCSA also had a large variability within subjects but less variation between subjects. The ratio of tendon slack length to optimal fascicle length was found to vary between 1.05 and 9.56. Using this data, a deformable model of the foot can now be created. It is envisioned that deformable feet will significantly improve stability and realism in models of gait, posture, and sporting activities.

[1]  R L Lieber,et al.  Sarcomere length operating range of vertebrate muscles during movement. , 2001, The Journal of experimental biology.

[2]  N. Stickland,et al.  A detailed analysis of the effects of various fixatives on animal tissue with particular reference to muscle tissue. , 1975, Stain technology.

[3]  M G Pandy,et al.  Static and dynamic optimization solutions for gait are practically equivalent. , 2001, Journal of biomechanics.

[4]  B. Hirsch,et al.  Pennation angles of the intrinsic muscles of the foot. , 2001, Journal of biomechanics.

[5]  M. Cornwall,et al.  Motion of the calcaneus, navicular, and first metatarsal during the stance phase of walking. , 2002, Journal of the American Podiatric Medical Association.

[6]  F M van Krieken,et al.  A model of lower extremity muscular anatomy. , 1982, Journal of biomechanical engineering.

[7]  D. Winter,et al.  Biomechanical model of the human foot: kinematics and kinetics during the stance phase of walking. , 1993, Journal of biomechanics.

[8]  A. J. van den Bogert,et al.  Direct dynamics simulation of the impact phase in heel-toe running. , 1995, Journal of biomechanics.

[9]  N. Sharkey,et al.  A dynamic cadaver model of the stance phase of gait: performance characteristics and kinetic validation. , 1998, Clinical biomechanics.

[10]  A. Cutts.  An in vitro method for the measurement of sarcomere length in human muscle. , 1987, Engineering in medicine.

[11]  M. Rodgers.  Dynamic foot biomechanics. , 1995, The Journal of orthopaedic and sports physical therapy.

[12]  F. Zajac,et al.  A musculoskeletal model of the human lower extremity: the effect of muscle, tendon, and moment arm on the moment-angle relationship of musculotendon actuators at the hip, knee, and ankle. , 1990, Journal of biomechanics.

[13]  N. McKee,et al.  Comparing human skeletal muscle architectural parameters of cadavers with in vivo ultrasonographic measurements , 2001, Journal of anatomy.

[14]  M J Shereff,et al.  In Vitro Determination of Midfoot Motion , 1989, Foot & ankle.

[15]  V. Edgerton,et al.  Muscle architecture of the human lower limb. , 1983, Clinical orthopaedics and related research.

[16]  P. Brand,et al.  Relative tension and potential excursion of muscles in the forearm and hand. , 1981, The Journal of hand surgery.

[17]  A. Cutts,et al.  Shrinkage of muscle fibres during the fixation of cadaveric tissue. , 1988, Journal of anatomy.

[18]  R. R. NEPTUNE,et al.  A Method for Numerical Simulation of Single Limb Ground Contact Events: Application to Heel-Toe Running , 2000, Computer methods in biomechanics and biomedical engineering.

[19]  K. An,et al.  Quantitative analysis of the intrinsic muscles of the foot , 1997, The Anatomical record.

[20]  J C Otis,et al.  A closed-loop cadaveric foot and ankle loading model. , 2001, Journal of biomechanics.

[21]  F.E. Zajac,et al.  Restoring unassisted natural gait to paraplegics via functional neuromuscular stimulation: a computer simulation study , 1990, IEEE Transactions on Biomedical Engineering.

[22]  R. Baskin,et al.  Sarcomere length determination using laser diffraction. Effect of beam and fiber diameter. , 1984, Biophysical journal.

[23]  F. Zajac.  Muscle and tendon: properties, models, scaling, and application to biomechanics and motor control. , 1989, Critical reviews in biomedical engineering.

[24]  F. Zajac,et al.  Contributions of the individual ankle plantar flexors to support, forward progression and swing initiation during walking. , 2001, Journal of biomechanics.

[25]  F.E. Zajac,et al.  An interactive graphics-based model of the lower extremity to study orthopaedic surgical procedures , 1990, IEEE Transactions on Biomedical Engineering.

[26]  B. Brenner,et al.  A laser diffraction method for measuring muscle sarcomere length in vivo for application to tendon transfers. , 1985, The Journal of hand surgery.

[27]  M. Pandy,et al.  A Dynamic Optimization Solution for Vertical Jumping in Three Dimensions. , 1999, Computer methods in biomechanics and biomedical engineering.