Organic semiconductor-based photovoltaic devices offer the promise of a low-cost photovoltaic technology that could be manufactured via large-scale, roll-to-roll printing techniques. Existing organic photovoltaic devices have currently achieved solar power conversion efficiencies greater than 3%. Although encouraging, the reasons higher efficiencies have not been achieved are poor overlap between the absorption spectrum of the organic chromophores and the solar spectrum, non-ideal band alignment between the donor and acceptor species, and low charge carrier mobilities resulting from the disordered nature of organic semiconductors. To address the latter issues, we are investigating the development of nanostructured oxide/conjugated polymer composite photovoltaic (PV) devices. These composites can take advantage of the high electron mobilities attainable in oxide semiconductors and can be fabricated using low-temperature solution-based growth techniques. Additionally, the morphology of the composite can be controlled in a systematic way through control of the nanostructured oxide growth. ZnO nanostructures that are vertically aligned with respect to the substrate have been grown. Here we discuss the fabrication of such nanostructures and present results from ZnO nanofiber/poly(3-hexylthiophene) (P3HT) composite PV devices. The best performance with this cell structure produced an open circuit voltage (Voc) of 440 mV, a short circuit current density (Jsc) of 2.2 mA/cm2, a fill factor (FF) of 0.56, and a conversion efficiency (η) of 0.53%. Incorporation of a blend of P3HT and (6,6)-phenyl C61 butyric acid methyl ester (PCBM) into the ZnO nanofibers produced enhanced performance with a Voc of 475 mV, Jsc of 10.0 mA/cm2, FF of 0.43, and η of 2.03%. The power efficiency is limited in these devices by the large fiber spacing and the reduced Voc.
[1]
W. J. Beek,et al.
Efficient Hybrid Solar Cells from Zinc Oxide Nanoparticles and a Conjugated Polymer
,
2004
.
[2]
Niyazi Serdar Sariciftci,et al.
Effects of Postproduction Treatment on Plastic Solar Cells
,
2003
.
[3]
Karol Putyera,et al.
Dekker Encyclopedia of Nanoscience and Nanotechnology
,
2004
.
[4]
Yunzhi Liu,et al.
Infiltrating Semiconducting Polymers into Self‐Assembled Mesoporous Titania Films for Photovoltaic Applications
,
2003
.
[5]
L. Vayssieres.
Growth of Arrayed Nanorods and Nanowires of ZnO from Aqueous Solutions
,
2003
.
[6]
Lenneke H. Slooff,et al.
Photoinduced Electron Transfer and Photovoltaic Response of a MDMO‐PPV:TiO2 Bulk‐Heterojunction
,
2003
.
[7]
Brian A. Gregg,et al.
Epitaxial chemical deposition of ZnO nanocolumns from NaOH solutions.
,
2004
.
[8]
L. Dloczik,et al.
Nano-structures for solar cells with extremely thin absorbers
,
2002
.
[9]
Toshinobu Yoko,et al.
Sol-gel preparation of ZnO films with extremely preferred orientation along (002) plane from zinc acetate solution
,
1997
.
[10]
Marius Grundmann,et al.
High electron mobility of epitaxial ZnO thin films on c-plane sapphire grown by multistep pulsed-laser deposition
,
2003
.