Losses in a flow through conduit components of a pipe system can be accounted for by head loss coefficients K. They can either be determined experimentally or from numerical solutions of the flow field. The physical interpretation is straight forward when these losses are related to the entropy generation in the flow field. This can be done based on the numerical solutions by the second law analysis (SLA) successfully applied for steady flows in the past. This analysis here is extended to unsteady laminar flow, exemplified by a periodic pulsating mass flow rate with the pulsation amplitude and the frequency as crucial parameters. First the numerical model is validated by comparing it to results for unsteady laminar pipe flow with analytical solutions for this case. Then K-values are determined for the benchmark case of a 90deg bend with a square cross section which is well-documented for the steady case already. It turns out that time averaged values of K may significantly deviate from the corresponding steady values. The K-values determined for steady flow are a good approximation for the time-averaged values in the unsteady case only for small frequencies and small amplitudes. [DOI: 10.1115/1.4023196]
[1]
Tianshou Zhao,et al.
The Friction Coefficient of A Fully-Developed Laminar Reciprocating Flow in a Circular Pipe
,
1996
.
[2]
Donald S. Miller.
Internal Flow Systems
,
1990
.
[3]
Heinz Herwig,et al.
Internal Flow Losses: A Fresh Look at Old Concepts
,
2011
.
[4]
Heinz Herwig,et al.
Loss Coefficients in Laminar Flows: Indispensable for the Design of Micro Flow Systems
,
2010
.
[5]
Heinz Herwig,et al.
A Standard Method to Determine Loss Coefficients of Conduit Components Based on the Second Law of Thermodynamics
,
2012
.
[6]
Cesar J. Deschamps,et al.
Friction Factor Under Transient Flow Condition
,
2004
.
[7]
O. G. Martynenko,et al.
Handbook of hydraulic resistance
,
1986
.
[8]
Franz Durst,et al.
Pulsating laminar pipe flows with sinusoidal mass flux variations
,
2005
.
[9]
Heinz Herwig,et al.
The Role of Entropy Generation in Momentum and Heat Transfer
,
2012
.