Dual-Polarized Partially Reflective Surface Antenna With MEMS-Based Beamwidth Reconfiguration

A partially reflective surface (PRS) antenna design enabling 1-bit dynamic beamwidth control is presented. The antenna operates at X-band and is based on microelectromechanical systems (MEMS) technology. The reconfigurable PRS unit cell monolithically integrates MEMS elements, whose positions are chosen to reduce losses while allowing a considerable beamwidth variation. The combined use of the proposed PRS unit cell topology and MEMS technology allows achieving low loss in the reconfigurable PRS. In addition, the antenna operates in dual-linear polarization with independent beamwidth control of each polarization. An operative MEMS-based PRS unit cell is fabricated and measured upon reconfiguration, showing very good agreement with simulations. The complete antenna system performance is rigorously evaluated based on full-wave simulations and the unit cell measurements, demonstrating an 18° and 23° variation of the half-power beamwidth in the E-plane and the H-plane, respectively. The antenna radiation efficiency is better than 75% in all states of operation.

[1]  Gabriel M. Rebeiz,et al.  Compact Low-Loss Tunable $X$-Band Bandstop Filter With Miniature RF-MEMS Switches , 2010, IEEE Transactions on Microwave Theory and Techniques.

[2]  J. Papapolymerou,et al.  Design, fabrication, and measurements of an RF-MEMS-based self-similar reconfigurable antenna , 2006, IEEE Transactions on Antennas and Propagation.

[3]  George Goussetis,et al.  High-gain subwavelength resonant cavity antennas based on metamaterial ground planes , 2006 .

[4]  Constantine A. Balanis,et al.  Antenna Theory: Analysis and Design , 1982 .

[5]  Dimitris E. Anagnostou,et al.  Bandwidth Enhancement of the Resonant Cavity Antenna by Using Two Dielectric Superstrates , 2013, IEEE Transactions on Antennas and Propagation.

[6]  A. Weily,et al.  A Reconfigurable High-Gain Partially Reflecting Surface Antenna , 2008, IEEE Transactions on Antennas and Propagation.

[7]  A.K. Skrivervik,et al.  Monolithic MEMS-Based Reflectarray Cell Digitally Reconfigurable Over a 360 $^{\circ }$ Phase Range , 2008, IEEE Antennas and Wireless Propagation Letters.

[8]  T. Akin,et al.  Low-Loss Ku-Band Artificial Transmission Line With MEMS Tuning Capability , 2009, IEEE Microwave and Wireless Components Letters.

[9]  L. Shafai,et al.  Investigation Into the Effects of the Patch-Type FSS Superstrate on the High-Gain Cavity Resonance Antenna Design , 2010, IEEE Transactions on Antennas and Propagation.

[10]  Juraj Bartolic,et al.  Equivalent surface modelling for reconfigurable partially reflective surface antennas , 2011, Proceedings of the 5th European Conference on Antennas and Propagation (EUCAP).

[11]  J. Vardaxoglou,et al.  Artificial magnetic conductor surfaces and their application to low-profile high-gain planar antennas , 2005, IEEE Transactions on Antennas and Propagation.

[12]  J. Perruisseau-Carrier.  Optimal Cell Topology Constraint for Monolayer Dual-Polarized Beamscanning Reflectarrays , 2012, IEEE Antennas and Wireless Propagation Letters.

[13]  Julien Perruisseau-Carrier,et al.  Proof of Concept of a Dual-Band Circularly-Polarized RF MEMS Beam-Switching Reflectarray , 2012, IEEE Transactions on Antennas and Propagation.

[14]  J. Perruisseau-Carrier.  Dual-Polarized and Polarization-Flexible Reflective Cells With Dynamic Phase Control , 2010, IEEE Transactions on Antennas and Propagation.

[15]  Y. Demers,et al.  EBG Superstrate Array Configuration for the WAAS Space Segment , 2009, IEEE Transactions on Antennas and Propagation.

[16]  Filippo Capolino,et al.  Array thinning by using antennas in a Fabry-Perot cavity for gain enhancement , 2006 .

[17]  J. C. Vardaxoglou,et al.  A broadband high-gain resonant cavity antenna with single feed , 2006, 2006 First European Conference on Antennas and Propagation.

[18]  B. Margesin,et al.  A Flexible Fabrication Process for RF MEMS Devices , 2012 .

[19]  M. Garcia-Vigueras,et al.  Novel topology of Fabry-Perot electronically steerable leaky-wave antenna , 2012, 2012 6th European Conference on Antennas and Propagation (EUCAP).

[20]  T Debogovic,et al.  Partially Reflective Surface Antenna With Dynamic Beamwidth Control , 2010, IEEE Antennas and Wireless Propagation Letters.

[21]  Zhi-Hang Wu,et al.  Broadband Printed Compound Air-Fed Array Antennas , 2010, IEEE Antennas and Wireless Propagation Letters.

[22]  J. Vardaxoglou,et al.  High gain planar antenna using optimised partially reflective surfaces , 2001 .

[23]  J. Perruisseau-Carrier,et al.  Array-fed partially reflective surface antenna with dynamic beamwidth control and beam-steering , 2012, 2012 6th European Conference on Antennas and Propagation (EUCAP).

[24]  Juraj Bartolic,et al.  On the dynamic beamwidth control of partially reflective surface antennas , 2011 .

[25]  J. A. Encinar,et al.  Characterization of a Reflectarray Gathered Element With Electronic Control Using Ohmic RF MEMS and Patches Aperture-Coupled to a Delay Line , 2012, IEEE Transactions on Antennas and Propagation.

[26]  A. D. Olver,et al.  Variable beamwidth reflector antenna by feed defocusing , 1995 .

[27]  Yuehe Ge,et al.  The Use of Simple Thin Partially Reflective Surfaces With Positive Reflection Phase Gradients to Design Wideband, Low-Profile EBG Resonator Antennas , 2012, IEEE Transactions on Antennas and Propagation.

[28]  T. Akin,et al.  Beam Switching Reflectarray Monolithically Integrated With RF MEMS Switches , 2012, IEEE Transactions on Antennas and Propagation.

[29]  Nicolaos G. Alexopoulos,et al.  Gain enhancement methods for printed circuit antennas , 1984 .

[30]  D. Jackson,et al.  General formulas for 2-D leaky-wave antennas , 2005, IEEE Transactions on Antennas and Propagation.

[31]  G. V. Trentini.  Partially reflecting sheet arrays , 1956 .