Role of hard martensite phase prior to cold-rolling on microstructure evolution after annealing in ferritic stainless steel

[1]  K. Higashida,et al.  Effect of tempering conditions on inhomogeneous deformation behavior of ferrite-martensite dual-phase steels , 2011 .

[2]  Saeed Ziaei-Rad,et al.  Experimental and numerical study on geometrically necessary dislocations and non-homogeneous mechanical properties of the ferrite phase in dual phase steels , 2011 .

[3]  M. Kamaya,et al.  Correlation between Microstructural Scale Plastic Strain and Misorientation , 2010 .

[4]  Xin Sun,et al.  Stress and Strain Partitioning of Ferrite and Martensite during Deformation , 2009 .

[5]  J. Embury,et al.  Digital image correlation studies for microscopic strain distribution and damage in dual phase steels , 2007 .

[6]  T. Tsuchiyama,et al.  Ridging-free ferritic stainless steel produced through recrystallization of lath martensite , 2005 .

[7]  Y. Matsumoto,et al.  Effect of Initial Solidified Structure on Ridging Phenomenon and Texture in Type 430 Ferritic Stainless Steel Sheets , 2003 .

[8]  Dong Nyung Lee,et al.  The effect of texture on ridging of ferritic stainless steel , 2003 .

[9]  Yuichiro Koizumi,et al.  Ultragrain refinement of plain low carbon steel by cold-rolling and annealing of martensite , 2002 .

[10]  K. Tsuzaki,et al.  Recrystallization and formation of austenite in deformed lath martensitic structure of low carbon steels , 1982 .

[11]  G. Thomas,et al.  Effects of morphology on the mechanical behavior of a dual phase Fe/2Si/0.1C steel , 1981 .

[12]  R. G. Davies.  Influence of martensite composition and content on the properties of dual phase steels , 1978 .

[13]  H. Miyaji,et al.  Effect of the Distribution of Martensite Phase in a Hot-Rolled Sheet on the Ridging Phenomenon in 17Cr Stainless Steel , 1975 .

[14]  I. Tamura,et al.  On the Tensile Deformation Behaviour of Two-Phase Iron Alloys , 1975 .

[15]  B. Karlsson,et al.  Inhomogeneity in plastic deformation of two-phase steels , 1974 .

[16]  H. Chao.  Recent studies into the mechanism of ridging in ferritic stainless steels , 1973 .

[17]  R. Wright.  Anisotropic plastic flow in ferritic stainless steels and the “roping” phenomenon , 1972 .

[18]  H. Takechi,et al.  On the Mechanism of Ridging Phenomenon in 17%-Chromium Stainless Steel Sheets , 1967 .