Demonstration of the Benefits of DPF/FBC Systems on London Black Cabs

Future emissions limits are pushing vehicle manufacturers towards the fitting of Diesel Particulate Filters (DPFs) as original equipment. However due to the replacement rate of the vehicle fleet, there is a delay before the full benefit of these measures are fully realised. To overcome this problem, in areas with a particular problem such as heavily congested city centres, retrospective legislation has been, and may be introduced. Legislation mandating the retrofitting of DPFs obviously has an immediate effect on particulate emissions. In some countries including the UK there are also fiscal incentives to fit DPFs. Due to its duty cycle the London taxi or Black Cab is one of the more challenging areas of application for the DPF. Previous work has shown that the use of a fuel borne catalyst (FBC) can extend the operating range of DPF systems providing the possibility of a viable system for such applications. To assess the benefits of a DPF/FBC system and to demonstrate its viability on London Black Cabs a programme was undertaken using four vehicles representative of the older, "dirtier" vehicles in service. Four cars were fitted with a DPF, an on-board dosing system to meter the FBC into the fuel and a data logger to monitor the DPF performance. Emissions measurements were taken before and after fitting the DPF. The cars were then run on the road conducting normal taxi duties. After approximately 20000 km the cars were brought back for a further set of emissions measurements to be performed with the DPF fitted and again with the DPF removed. This paper summarises two earlier papers detailing the regulated and non-regulated emissions benefits at the start of the programme and then goes on to present data from the in-service performance of the systems.

[1]  Paul Richards,et al.  A Novel Fuel Borne Catalyst Dosing System for Use with a Diesel Particulate Filter , 2003 .

[2]  T. Seguelong,et al.  Use of Diesel Particulate Filters and Cerium-Based Fuel-Borne Catalyst for Low Temperature - Low Load Applications , 2001 .

[3]  O. Salvat,et al.  Passenger Car Serial Application of a Particulate Filter System on a Common Rail Direct Injection Diesel Engine , 2000 .

[4]  M. W. Vincent,et al.  Combining Fuel Borne Catalyst, Catalytic Wash Coat and Diesel Particulate Filter , 2001 .

[5]  K. Baumgard,et al.  Characterization of fuel and aftertreatment device effects on diesel emissions. , 1996, Research report.

[6]  Hua Zhao,et al.  The Dilution, Chemical, and Thermal Effects of Exhaust Gas Recirculation on Diesel Engine Emissions - Part 1: Effect of Reducing Inlet Charge Oxygen , 1996 .

[7]  N Ladommatos,et al.  The dilution, chemical, and thermal effects of exhaust gas recirculation on diesel engine emissions-part 2: Effects of carbon dioxide , 1996 .

[8]  Dana Lowell,et al.  Performance and Durability Evaluation of Continuously Regenerating Particulate Filters on Diesel Powered Urban Buses at NY City Transit , 2001 .

[9]  Paul Richards,et al.  Operating Experience of Diesel Vehicles Equipped with Particulate Filters and Using Fuel Additive for Regeneration , 2000 .

[10]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[11]  Paul Richards,et al.  Experience of Fitting London Black Cabs with Fuel Borne Catalyst Assisted Diesel Particulate Filters - Part 2 Non-Regulated Emissions Measurements , 2002 .

[12]  Paul Richards,et al.  The Long Distance Road Trial of a Combined Diesel Particulate Filter and Fuel Additive , 2000 .

[13]  Paul Richards,et al.  Experience of Fitting London Black Cabs with Fuel Borne Catalyst Assisted Diesel Particulate Filters - Part 1 Regulated Emissions and Regeneration Performance , 2002 .

[14]  J. Czerwinski,et al.  Particulate Traps for Construction Machines Properties and Field Experience , 2000 .

[15]  Anastassios M. Stamatelos,et al.  Modeling Catalytic Regeneration of Diesel Particulate Filters, Taking into Account Adsorbed Hydrocarbon Oxidation , 1999 .