论文信息 - NiO–ScSZ and Ni0.9Mg0.1O–ScSZ-based anodes under internal dry reforming of simulated biogas mixtures

NiO–ScSZ and Ni0.9Mg0.1O–ScSZ-based anodes under internal dry reforming of simulated biogas mixtures

Abstract Solid oxide fuel cells (SOFCs) with NiO–ScSZ and Ni0.9Mg0.1O–ScSZ-based anodes were operated by directly feeding a fuel mixture of CH4, CO2 and N2 (CH4 to CO2 ratio of 3:2). Stable operation under constant current load (200 mA cm−2) was achieved with a NiO–ScSZ type anode during 200 h operating hours at 900 °C. Less stable operation occurred with a Ni0.9Mg0.1O–ScSZ type anode. In the case of SOFC with Ni0.9Mg0.1O–ScSZ as the anode, the methane reforming activity was higher than that with NiO–ScSZ. This was explained by change in the microstructure promoting reforming reactions. However, the addition of MgO resulted in degradation of electrochemical performance due to increase in ohmic resistance of the anode material during operation.

Kazunari Sasaki | Yusuke Shiratori | K. Sasaki | Y. Shiratori

[1] D. Moon,et al. Electrocatalytic reforming of carbon dioxide by methane in SOFC system , 2003 .

[2] A. Boréave,et al. Catalytic CO2 reforming of methane over Ir/Ce0.9Gd0.1O2−x , 2005 .

[3] Kevin Kendall,et al. Biogas powering a small tubular solid oxide fuel cell , 1998 .

[4] I. Yentekakis,et al. Catalytic and electrocatalytic behavior of Ni-based cermet anodes under internal dry reforming of CH4 + CO2 mixtures in SOFCs , 2006 .

[5] K. Sasaki,et al. Ni1−x−yMgxAlyO–ScSZ anodes for solid oxide fuel cells , 2006 .

[6] I. Yentekakis,et al. Open-and closed-circuit study of an intermediate temperature SOFC directly fueled with simulated biogas mixtures , 2006 .

[7] Kazunari Sasaki,et al. Equilibria in Fuel Cell Gases II. The C-H-O Ternary Diagrams , 2003 .

[8] Doris Sebold,et al. Optimisation of processing and microstructural parameters of LSM cathodes to improve the electrochemical performance of anode-supported SOFCs , 2005 .