Natural Ventilated Smoke Control Simulation Case Study Using Different Settings of Smoke Vents and Curtains in a Large Atrium

In this study, a Large Eddy Simulation (LES) based fire field model was applied to numerically investigate the effectiveness of smoke control using smoke vents and curtains within a large-scale atrium fire. Two compartment configurations were considered: the first case with no smoke curtains installed, while the second case included a smoke curtain at the centre of the compartment to trap smoke. Based on the thermocouple results, it was found that the model predicted the gas temperature near the fire particularly well. The time development and heat transfer of the gas temperature predictions were in good agreement with the experimental measurements. Nevertheless, the gas temperature was slightly under-predicted when the thermocouple was further away from the flaming region. Overall, it was discovered that the combination of a smoke curtain and ceiling vents was a highly effective natural smoke exhaust system. However, under the same vent configuration, if the smoke curtain height is not adequate to completely block the spread of smoke, it significantly reduces the pressure differential between the compartment and the exterior, causing reduced flow rates in the outlet vents.

[1]  Guan Heng Yeoh,et al.  Fire scene investigation of an arson fire incident using computational fluid dynamics based fire simulation , 2014 .

[2]  Clayton Huggett,et al.  Estimation of rate of heat release by means of oxygen consumption measurements , 1980 .

[3]  Qing Nian Chan,et al.  Comparison of detailed soot formation models for sooty and non-sooty flames in an under-ventilated ISO room , 2017 .

[4]  Brian J. Meacham,et al.  Performance-based building regulation: current situation and future needs , 2005 .

[5]  Guillermo Rein,et al.  Influence of atrium roof geometries on the numerical predictions of fire tests under natural ventilation conditions , 2013 .

[6]  J. Smagorinsky,et al.  GENERAL CIRCULATION EXPERIMENTS WITH THE PRIMITIVE EQUATIONS , 1963 .

[7]  Angui Li,et al.  Fire-induced smoke control via hybrid ventilation in a huge transit terminal subway station , 2012 .

[8]  Qing Nian Chan,et al.  On the influences of key modelling constants of large eddy simulations for large-scale compartment fires predictions , 2017 .

[9]  Guan Heng Yeoh,et al.  Numerical Simulation of a Ceiling Jet Fire in a Large Compartment , 2013 .

[10]  L. J. Li,et al.  Determination of smoke layer interface height of medium scale tunnel fire scenarios , 2016 .

[11]  Fan Weicheng,et al.  A multi-layer zone model for predicting fire behavior in a fire room , 2005 .

[12]  G. Hadjisophocleous.  Experimental study and zone modeling of smoke movement in a model atrium , 2003 .

[13]  B. Hjertager,et al.  On mathematical modeling of turbulent combustion with special emphasis on soot formation and combustion , 1977 .

[14]  C. Gutiérrez-Montes,et al.  Influence of different make-up air configurations on the fire-induced conditions in an atrium , 2010 .

[15]  Tracie Barber,et al.  Importance of detailed chemical kinetics on combustion and soot modelling of ventilated and under-ventilated fires in compartment , 2016 .

[16]  Ha-Yong Kim,et al.  A study of optimal vent mode for the smoke control of subway station fire , 2006 .

[17]  J. Dupuy,et al.  Fire spread through a porous forest fuel bed: a radiative and convective model including fire-induced flow effects , 1999 .

[18]  Guan Heng Yeoh,et al.  NUMERICAL SIMULATION OF AN ENCLOSURE FIRE IN A LARGE TEST HALL , 2013 .

[19]  Brian J. Meacham,et al.  Twenty years of performance-based fire protection design: challenges faced and a look ahead , 2013 .

[20]  Bart Merci,et al.  Verification of the accuracy of CFD simulations in small-scale tunnel and atrium fire configurations , 2011 .

[21]  P. Ayala,et al.  The Use of Fractional Factorial Design for Atrium Fires Prediction , 2017 .

[22]  Qing Nian Chan,et al.  Synthesis of anhydrous manganese hypophosphite microtubes for simultaneous flame retardant and mechanical enhancement on poly(lactic acid) , 2018, Composites Science and Technology.

[23]  Yuan Hu,et al.  Manufacturing, mechanical and flame retardant properties of poly(lactic acid) biocomposites based on calcium magnesium phytate and carbon nanotubes , 2018, Composites Part A: Applied Science and Manufacturing.

[24]  N. Bénichou,et al.  DEVELOPMENT OF PERFORMANCE-BASED CODES , PERFORMANCE CRITERIA AND FIRE SAFETY ENGINEERING METHODS , 2001 .

[25]  Toshio Yamana,et al.  Smoke control in large scale spaces. Part 1: Analytic theories for simple smoke control problems.:(Part 1 : Analytic Theories For Simple Smoke Control Problems) , 1985 .

[26]  Wan Ki Chow,et al.  Oscillating behaviour of fire-induced air flow through a ceiling vent , 2009 .

[27]  W. Yang,et al.  Numerical study of the development and angular speed of a small-scale fire whirl , 2018, J. Comput. Sci..

[28]  Qing Nian Chan,et al.  Establishing pyrolysis kinetics for the modelling of the flammability and burning characteristics of solid combustible materials , 2018, Journal of Fire Sciences.

[29]  George Hadjisophocleous,et al.  An improved two-layer zone model applicable to both pre- and post-flashover fires , 2012 .

[30]  Wan Ki Chow,et al.  Natural smoke filling in atrium with liquid pool fires up to 1.6 MW , 2001 .

[31]  C. K. Chan,et al.  Numerical simulation of the spread of smoke in an atrium under fire scenario , 2009 .

[32]  Angui Li,et al.  Prediction of the spread of smoke in a huge transit terminal subway station under six different fire scenarios , 2012 .

[33]  Hao C. Tran,et al.  Data Reduction of Room Tests for Zone Model Validation , 1992 .

[34]  Andrew H. Buchanan,et al.  The Challenges of Predicting Structural Performance in Fires , 2008 .

[35]  J. Ji,et al.  Effects of ambient pressure on transport characteristics of thermal-driven smoke flow in a tunnel , 2018 .

[36]  J. Ji,et al.  Numerical Investigation on the Influence of Length–Width Ratio of Fire Source on the Smoke Movement and Temperature Distribution in Tunnel Fires , 2019, Fire Technology.

[37]  C. Gutiérrez-Montes,et al.  Numerical model and validation experiments of atrium enclosure fire in a new fire test facility , 2008 .

[38]  George Hadjisophocleous,et al.  Large-scale physical model studies for an atrium smoke exhaust system , 1999 .

[39]  Lizhong Yang,et al.  The inclination effect on CO generation and smoke movement in an inclined tunnel fire , 2012 .

[40]  Guillermo Rein,et al.  Experimental data and numerical modelling of 1.3 and 2.3 MW fires in a 20 m cubic atrium , 2009 .

[41]  W. Yang,et al.  Numerical study of fire spread using the level-set method with large eddy simulation incorporating detailed chemical kinetics gas-phase combustion model , 2018, J. Comput. Sci..

[42]  V. Timchenko,et al.  Predicting the fire spread rate of a sloped pine needle board utilizing pyrolysis modelling with detailed gas-phase combustion , 2018, International Journal of Heat and Mass Transfer.

[43]  Richard W. Bukowski,et al.  Developing rational, performance-based fire safety requirements in model building codes , 1994 .

[44]  Gary R. Hunt,et al.  Smoke filling time for a room due to a small fire: The effect of ceiling height to floor width aspect ratio , 2007 .

[45]  Takeyoshi Tanaka,et al.  A Multi-layer Zone Model For Predicting Fire Behavior In A Single Room , 2003 .

[46]  George. V. Hadjisophocleous,et al.  A two-zone fire growth and smoke movement model for multi-compartment buildings , 2000 .

[47]  W. Z. Black,et al.  Smoke movement in elevator shafts during a high-rise structural fire , 2009 .

[48]  Daniel Alvear,et al.  Scale Tests of Smoke Filling in Large Atria , 2009 .