Hot-electron reliability and ESD latent damage

The impact of noncatastrophic electrostatic discharge (ESD) stress on hot-electron reliability as well as the effect of hot-electron (HE) injection on the ESD protection threshold are discussed. It is found that there is a factor-of-two-to-four deterioration in hot-electron reliability after low-level ESD stress. These two effects can be viewed as similar although HE is a low-current long-time process and ESD is a high-current short-time process. Therefore, techniques for characterizing hot-electron degradation were applied to measure quantitatively the damage due to ESD stress. This technique showed electrical evidence of current filaments during an ESD discharge. >

[1]  C. Duvvury,et al.  ESD Phenomena and Protection Issues in CMOS Output Buffers , 1987, 25th International Reliability Physics Symposium.

[2]  R. N. Rountree,et al.  Internal chip ESD phenomena beyond the protection circuit , 1988 .

[3]  E. Takeda,et al.  Hot-carrier effects in submicrometre MOS VLSIs , 1984 .

[4]  Kueing-Long Chen,et al.  Electrostatic discharge protection for one micron CMOS devices and circuits , 1986, 1986 International Electron Devices Meeting.

[5]  J. Brugler,et al.  Charge pumping in MOS devices , 1969 .

[6]  G. Groeseneken,et al.  A reliable approach to charge-pumping measurements in MOS transistors , 1984, IEEE Transactions on Electron Devices.

[7]  Chenming Hu,et al.  Hot-Electron-Induced MOSFET Degradation - Model, Monitor, and Improvement , 1985, IEEE Journal of Solid-State Circuits.

[8]  N. Khurana,et al.  ESD on CHMOS Devices - Equivalent Circuits, Physical Models and Failure Mechanisms , 1985, 23rd International Reliability Physics Symposium.