Modelling and simulation of intensified absorber for post-combustion CO2 capture using different mass transfer correlations

Abstract This paper studied mass transfer in rotating packed bed (RPB) which has the potential to significantly reduce capital and operating costs in post-combustion CO2 capture. To model intensified absorber, mass transfer correlations were implemented in visual FORTRAN and then were dynamically linked with Aspen Plus® rate-based model. Therefore, this represents a newly developed model for intensified absorber using RPB. Two sets of mass transfer correlations were studied and compared through model validations. The second set of correlations performed better at the MEA concentrations tested as compared with the first set of correlations. For insights into the design and operation of intensified absorber, process analysis was carried out, which indicates: (a) With fixed RPB equipment size and fixed Lean MEA flow rate, CO2 capture level decreases with increase in flue gas flow rate; (b) Higher lean MEA inlet temperature leads to higher CO2 capture level. (c) At higher flue gas temperature (from 30 °C to 80 °C), the CO2 capture level of the intensified absorber can be maintained. Compared with conventional absorber using packed columns, the insights obtained from this study are (1) Intensified absorber using rotating packed bed (RPB) improves mass transfer significantly. (2) Cooling duty cost can be saved since higher lean MEA temperature and/or higher flue gas temperature shows little or no effect on the performance of the RPB.

[1]  H. M. Kvamsdal,et al.  Dynamic modeling and simulation of a CO2 absorber column for post-combustion CO2 capture , 2009 .

[2]  Gautam Biswas,et al.  Gas-Phase Mass Transfer in a Centrifugal Contactor , 2001 .

[3]  Richard S.H. Mah,et al.  MODELING LIQUID MASS TRANSFER IN HIGEE SEPARATION PROCESS , 1985 .

[4]  Yu-Shao Chen,et al.  Correlations of Mass Transfer Coefficients in a Rotating Packed Bed , 2011 .

[5]  Meihong Wang,et al.  Post-combustion CO2 capture with chemical absorption: A state-of-the-art review , 2011 .

[6]  Guang Q. Wang,et al.  Performance of a rotating zigzag bed—A new HIGEE , 2008 .

[7]  H. Yeung,et al.  Dynamic modelling and analysis of post-combustion CO2 chemical absorption process for coal-fired power plants , 2010 .

[8]  K. Shine,et al.  Intergovernmental panel on Climate change (IPCC),in encyclopedia of Enviroment and society,Vol.3 , 2007 .

[9]  Chung-Sung Tan,et al.  Reduction of CO2 concentration in a zinc/air battery by absorption in a rotating packed bed , 2006 .

[10]  Hanne M. Kvamsdal,et al.  Maintaining a neutral water balance in a 450 MWe NGCC-CCS power system with post-combustion carbon dioxide capture aimed at offshore operation , 2010 .

[11]  Chia-Chang Lin,et al.  Micromixing in a Rotating Packed Bed , 2004 .

[12]  Colin Ramshaw,et al.  Process intensification: operating characteristics of rotating packed beds - determination of liquid hold-up for a high-voidage structured packing , 2000 .

[13]  Chung-Sung Tan,et al.  CO2 capture from hot stove gas in steel making process , 2010 .

[14]  R. L. Hershey,et al.  Effect of Gas Velocity and Temperature on Rate of Absorption. , 1924 .

[15]  Johan Grievink,et al.  Process intensification and process systems engineering: A friendly symbiosis , 2008, Comput. Chem. Eng..

[16]  Meihong Wang,et al.  Dynamic modelling of CO2 absorption for post combustion capture in coal-fired power plants , 2009 .

[17]  Tick Hui Oh,et al.  Carbon capture and storage potential in coal-fired plant in Malaysia—A review , 2010 .

[18]  Jianfeng Chen,et al.  Gas–Liquid Effective Interfacial Area in a Rotating Packed Bed , 2012 .

[19]  Chia-Chang Lin,et al.  Packing Characteristics for Mass Transfer in a Rotating Packed Bed , 2006 .

[20]  David Reay,et al.  The role of process intensification in cutting greenhouse gas emissions , 2008 .

[21]  Peter Stephenson,et al.  Dynamic Modeling and Simulation of CO2 Chemical Absorption Process for Coal-Fired Power Plants , 2009 .

[22]  Estrella Alvarez,et al.  Effect of temperature on carbon dioxide absorption in monoethanolamine solutions , 2008 .

[23]  Nitin Kaistha,et al.  Process Intensification in HiGee Absorption and Distillation: Design Procedure and Applications , 2010 .

[24]  Hiroshi Takeuchi,et al.  GAS ABSORPTION WITH CHEMICAL REACTION IN PACKED COLUMNS , 1968 .

[25]  J. Plaza,et al.  Modeling CO2 capture with aqueous monoethanolamine , 2003 .

[26]  Meihong Wang,et al.  Demonstrating full-scale post-combustion CO2 capture for coal-fired power plants through dynamic modelling and simulation , 2012 .

[27]  C. Ramshaw,et al.  Process analysis of intensified absorber for post-combustion CO2 capture through modelling and simulation , 2014 .

[28]  Chechet Biliyok,et al.  Dynamic modelling, validation and analysis of post-combustion chemical absorption CO2 capture plant , 2012 .

[29]  W. K. Lewis,et al.  Principles of Gas Absorption. , 1924 .

[30]  Nilay Shah,et al.  An overview of CO2 capture technologies , 2010 .

[31]  Colin Ramshaw,et al.  Carbon dioxide absorption and desorption in aqueous monoethanolamine solutions in a rotating packed bed , 2007 .

[32]  Chia-Chang Lin,et al.  Evaluation of alkanolamine solutions for carbon dioxide removal in cross-flow rotating packed beds. , 2010, Journal of hazardous materials.