Backside illuminated dye-sensitized solar cells based on titania nanotube array electrodes

Backside illuminated solar cells based on 6 µm long highly-ordered nanotube-array films sensitized by a self-assembled monolayer of bis(tetrabutylammonium)-cis-(dithiocyanato)- N,N'-bis(4-carboxylato-4'-carboxylic acid-2, 2'-bipyridine)ruthenium(II) (commonly called 'N719') show a short-circuit current density of 8.79 mA cm−2, 841 mV open circuit potential and a 0.57 fill factor yielding a power conversion efficiency of 4.24% under AM 1.5 sun. The solvent used to infiltrate the dye into the nanotube arrays, made by potentiostatic anodization of a titanium foil, was found to significantly influence the electrical characteristics of the resulting solar cell. A superior photoresponse was obtained with acetonitrile as the dye solvent. This is attributed to the improved wetting characteristics of the dye solution in acetonitrile enabling self-assembled monolayers with higher surface coverage to be formed inside the nanotubes. In comparison to nanocrystalline films, the nanotube-array films consistently exhibit larger open circuit photovoltage values; the origins of this enhancement are discussed.

[1]  Takayuki Kitamura,et al.  Origin of enhancement in open-circuit voltage by adding ZnO to nanocrystalline SnO2 in dye-sensitized solar cells. , 2005, The journal of physical chemistry. B.

[2]  Michael Grätzel,et al.  Applications of functionalized transition metal complexes in photonic and optoelectronic devices , 1998 .

[3]  C. Grimes,et al.  Water-photolysis properties of micron-length highly-ordered titania nanotube-arrays. , 2005, Journal of nanoscience and nanotechnology.

[4]  Craig A. Grimes,et al.  The effect of electrolyte composition on the fabrication of self-organized titanium oxide nanotube arrays by anodic oxidation , 2005 .

[5]  A. J. Frank,et al.  Electrons in nanostructured TiO2 solar cells: Transport, recombination and photovoltaic properties , 2004 .

[6]  Eugeniu Balaur,et al.  Wetting behaviour of layers of TiO2 nanotubes with different diameters , 2005 .

[7]  Patrik Schmuki,et al.  High-aspect-ratio TiO2 nanotubes by anodization of titanium. , 2005, Angewandte Chemie.

[8]  L. Peter,et al.  Frequency-Resolved Optical Detection of Photoinjected Electrons in Dye-Sensitized Nanocrystalline Photovoltaic Cells , 1999 .

[9]  M. Grätzel.  Corrigendum to “Conversion of sunlight to electric power by nanocrystalline dye-sensitized solar cells” [J. Photochem. Photobiol. A: Chem. 164 (2004) 3–14] , 2004 .

[10]  Peidong Yang,et al.  Nanowire dye-sensitized solar cells , 2005, Nature materials.

[11]  S. Yoshikawa,et al.  Formation of Titania Nanotubes and Applications for Dye-Sensitized Solar Cells , 2003 .

[12]  M. Grätzel,et al.  A low-cost, high-efficiency solar cell based on dye-sensitized colloidal TiO2 films , 1991, Nature.

[13]  K. Tennakone,et al.  Suppression of recombinations in a dye-sensitized photoelectrochemical cell made from a film of tin iv oxide crystallites coated with a thin layer of aluminium oxide , 2001 .

[14]  Craig A Grimes,et al.  Enhanced photocleavage of water using titania nanotube arrays. , 2005, Nano letters.

[15]  Jan M. Macak,et al.  Titanium oxide nanotubes prepared in phosphate electrolytes , 2005 .

[16]  Craig A. Grimes,et al.  Titanium oxide nanotube arrays prepared by anodic oxidation , 2001 .

[17]  Craig A. Grimes,et al.  Unprecedented ultra-high hydrogen gas sensitivity in undoped titania nanotubes , 2006 .

[18]  Craig A. Grimes,et al.  Crystallization and high-temperature structural stability of titanium oxide nanotube arrays , 2003 .