Experimental and Numerical Investigations of Close-Coupled Pilot Injections to Reduce Combustion Noise in a Small-Bore Diesel Engine

[1]  S. Busch,et al.  Parametric Study of Injection Rates With Solenoid Injectors in an Injection Quantity and Rate Measuring Device , 2014 .

[2]  R. Reitz,et al.  On the Dependence of Spray Angle and Other Spray Parameters on Nozzle Design and Operating Conditions , 1979 .

[3]  Nigel J. B. McFarlane,et al.  Segmentation and tracking of piglets in images , 1995, Machine Vision and Applications.

[4]  S. W. Nicol,et al.  Modulation of Injection Rate to Improve Direct Injection Diesel Engine Noise , 1990 .

[5]  A. Leipertz,et al.  The Impact of Fuel Mass, Injection Pressure, Ambient Temperature, and Swirl Ratio on the Mixture Preparation of a Pilot Injection , 2013 .

[6]  F. Lavoisier,et al.  Optimizing the Multiple Injection Settings on an HSDI Diesel Engine , 2004 .

[7]  P. Miles,et al.  Measurement of Equivalence Ratio in a Light-Duty Low Temperature Combustion Diesel Engine by Planar Laser Induced Fluorescence of a Fuel Tracer , 2011 .

[8]  Federico Millo,et al.  Experimental Investigation on Soot and NOx Formation in a DI Common Rail Diesel Engine with Pilot Injection , 2001 .

[9]  Paul C. Miles,et al.  On the Cyclic Variability and Sources of Unburned Hydrocarbon Emissions in Low Temperature Diesel Combustion Systems. , 2007 .

[10]  Arsham J. Shahlari,et al.  Comparison of Compression Ignition Engine Noise Metrics in Low-Temperature Combustion Regimes , 2013 .

[11]  J. Naber,et al.  Effects of Gas Density and Vaporization on Penetration and Dispersion of Diesel Sprays , 1996 .

[12]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[13]  A. Leipertz,et al.  Pilot Injection Ignition Properties Under Low-Temperature, Dilute In-Cylinder Conditions , 2013 .

[14]  G. Bruneaux,et al.  Laser-Induced Phosphorescence Measurements of Combustion Chamber Surface Temperature on a Single-Cylinder Diesel Engine , 2011 .

[15]  Raul Payri,et al.  Macroscopic Behavior of Diesel Sprays in the Near-Nozzle Field , 2008 .

[16]  H. Hiroyasu,et al.  Structures of fuel sprays in diesel engines , 1990 .

[17]  Michael F. J. Brunt,et al.  Calculation of Heat Release in Direct Injection Diesel Engines , 1999 .

[18]  Christian Hasse,et al.  Modelling of ignition mechanisms and pollutant formation in direct-injection diesel engines with multiple injections , 2005 .

[19]  Helmut Endres,et al.  Preinjection A Measure to Optimize the Emission Behavior of DI-Diesel Engine , 1994 .

[20]  S. Garg,et al.  Heat capacities and densities of liquid n-octane, n-nonane, n-decane, and n-hexadecane at temperatures from 318.15 K to 373.15 K and at pressures up to 10 MPa , 1991 .