The effect of injection level and cooling method on the quality of cooked ham joints.

The effect of cooling method and injection level on cooling rate, weight loss and quality of large cooked ham joints was investigated. Two cooling methods, vacuum (VC) and conventional (CC) and two injection levels (20 and 30%) were examined. VC reduced the cooling rate (70 °C to 4 °C) significantly in comparison to the CC (2.5 h vs. 12.5 h). Under these test conditions, VC conformed to recent safety guidelines for cooked meat joints of a reduction in temperature to 5 °C inside 10 h in comparison to CC. The injection rate had no affect on the cooling rate. Increased weight loss due to vacuum cooling was off-set by increasing the level of brine injection in pork legs from 20 to 30% and getting a yield after VC similar to that for CC hams injected at 20%. Injection rate had no affect on the sensory attributes but cooling method did; VC hams were slightly tougher (P<0.05) and drier (P<0.01) than CC hams. While VC hams injected to a 30% rate were less tender and juicy than CC hams injected at a 20% rate, as indicated by sensory scores and some instrumental texture parameters, they were similar in shear value and in overall acceptability.

[1]  Karl McDonald,et al.  The formation of pores and their effects in a cooked beef product on the efficiency of vacuum cooling , 2001 .

[2]  Karl McDonald,et al.  The effect of injection level on the quality of a rapid vacuum cooled cooked beef product , 2001 .

[3]  Karl McDonald,et al.  Comparison of the Quality of Cooked Beef Products Cooled by Vacuum Cooling and by Conventional Cooling , 2000 .

[4]  J. Gaze,et al.  Identification and prevention of hazards associated with slow cooling of hams and other large cooked meats and meat products , 1998 .

[5]  Da-Wen Sun,et al.  Vacuum cooling technology for the food processing industry: a review , 2000 .

[6]  S James,et al.  The chill chain "from carcass to consumer". , 1996, Meat science.

[7]  Da-Wen Sun,et al.  Heat transfer characteristics of cooked meats using different cooling methods , 2000 .

[8]  K. Niranjan,et al.  Process Engineering in the Food Industry — 2 convenience foods and quality assurance , 1991 .

[9]  T. Kenny,et al.  Effect of rapid and conventional cooling methods on the quality of cooked ham joints. , 2000, Meat science.

[10]  Malcolm C. Bourne,et al.  Texture profile analysis , 1978 .

[11]  Harold Egan,et al.  Pearson's Composition and Analysis of Foods , 1991 .

[12]  J. A. Martı́nez,et al.  Influence of packaging treatments on the keeping quality of 'Salinas' lettuce , 1996 .

[13]  J. Arey,et al.  Automated methods for determination of fat and moisture in meat and poultry products: collaborative study. , 1985, Journal - Association of Official Analytical Chemists.

[14]  R A Sweeney,et al.  Comparison of LECO FP-228 "nitrogen determinator" with AOAC copper catalyst Kjeldahl method for crude protein. , 1987, Journal - Association of Official Analytical Chemists.