A capacitive pressure sensor using hybrid silicon-glass structure for hermetic wafer level packaging

A design of barometric capacitive pressure sensor is presented in this paper, which is compatible with the standard CMOS process, and a new wafer level packaging is used to seal the vacuum cavity with a glass-silicon hybrid wafer which has a certain pattern. The electrodes of the sensor are leaded out by through silicon via (TSV) technology from back side of the silicon substrate. Mechanical characteristics of the sensor are analyzed by ANSYS. The initial gap of both electrodes formed the capacitor is 2 µm, and the size of the square membrane is 700 µm. The simulation results show the sensitivity of the sensor is 2.84fF/hPa, and the nonlinearity of the device is less than 1.1% over a dynamic range 700–1100 hPa. It is shown that the device is suitable to be used in measuring the barometric pressure.

[1]  K. Schjølberg-Henriksen,et al.  Sodium contamination of SiO2 caused by anodic bonding , 2003 .

[2]  Wen H. Ko,et al.  Solid-state capacitive pressure transducers , 1986 .

[3]  Masayoshi Esashi,et al.  Deep reactive ion etching of Pyrex glass , 2000, Proceedings IEEE Thirteenth Annual International Conference on Micro Electro Mechanical Systems (Cat. No.00CH36308).

[4]  Hyeon Cheol Kim,et al.  Improvement of the linearity of a capacitive pressure sensor using an interdigitated electrode structure , 1997 .

[5]  Kensall D. Wise,et al.  High-speed MEMS-based gas chromatography , 2004 .

[6]  Kensall D. Wise,et al.  Batch-processed vacuum-sealed capacitive pressure sensors , 2001 .

[7]  Qing-An Huang,et al.  Micromachining of Pyrex7740 glass and their applications to wafer-level hermetic packaging of MEMS devices , 2010, 2010 IEEE 23rd International Conference on Micro Electro Mechanical Systems (MEMS).

[8]  Y. Gianchandani,et al.  A low cost batch-sealed capacitive pressure sensor , 1999, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[9]  Wen H. Ko,et al.  Touch mode capacitive pressure sensors , 1999 .

[10]  Yogesh B. Gianchandani,et al.  A servo-controlled capacitive pressure sensor using a capped-cylinder structure microfabricated by a three-mask process , 2003 .

[11]  K. Wise,et al.  An ultraminiature solid-state pressure sensor for a cardiovascular catheter , 1988 .

[12]  Chong H. Ahn,et al.  A thick film screen-printed ceramic capacitive pressure microsensor for high temperature applications , 2006 .

[13]  Pasqualina M. Sarro,et al.  Pressure, flow and oxygen saturation sensors on one chip for use in catheters , 2000, Proceedings IEEE Thirteenth Annual International Conference on Micro Electro Mechanical Systems (Cat. No.00CH36308).