The occurrence of illnesses related with poor ventilation has driven an increasing attention towards indoor air quality monitoring. In buildings equipped with climate control systems, the diseases related to the air quality can be significantly reduced if smart intervening procedures, aiming to control the concentration of pollutants in the indoor air, can be implemented in the heating, ventilation air conditioning unit. When reliable information about both the indoor and outdoor air quality is made available, the climate control system can provide the most appropriate amount of ventilation, ensuring safe and comfortable living conditions. In this paper, a dedicated, miniaturized, low-cost electronic nose based on state-of-the-art metal oxide sensors and signal processing techniques was developed. The proposed device is targeted to the quantification of carbon monoxide and nitrogen dioxide in mixtures with relative humidity and volatile organic compounds by using an optimized gas sensor array and highly effective pattern recognition techniques. The electronic nose was tested in an environment reproducing real operating conditions. Exploiting the unique response patterns of the different sensors in the array and the capability of a simple fuzzy-logic system it was possible to identify and discriminate concentrations as low as 20 ppb for NO2 and 5 ppm for CO in the test gas environment, allowing to reach the necessary sensitivity towards the target pollutants together with the selectivity towards the typical interfering gas species. © 2004 Elsevier B.V. All rights reserved.
[1]
Giorgio Sberveglieri,et al.
LETTER TO THE EDITOR: A new technique for growing large surface area SnO2 thin film (RGTO technique)
,
1990
.
[2]
Giorgio Sberveglieri,et al.
A thin-film SnO2 sensor system for simultaneous detection of CO and NO2 with neural signal evaluation
,
1996
.
[3]
W. Benecke,et al.
Application of a membrane reactor and an ultra-short packed gas chromatographic column to optimize the gas selectivity of a resistive thin film gas sensor
,
2003,
The Sixteenth Annual International Conference on Micro Electro Mechanical Systems, 2003. MEMS-03 Kyoto. IEEE.
[4]
J. E. Janssen,et al.
Ventilation for acceptable indoor air quality
,
1989
.
[5]
Anibal T. de Almeida,et al.
Sensor-based demand-controlled ventilation: a review
,
1998
.
[6]
Ivan Elmi,et al.
Use of different sensing materials and deposition techniques for thin-film sensors to increase sensitivity and selectivity
,
2003
.