Replication of deep micro-optical components prototyped by Deep Proton Writing

Using our rapid prototyping technology called Deep Proton Writing (DPW), we have in recent years made a wide range of micro-optical components with a large depth (500-μm) for a variety of applications. One of these components is a pluggable out-of-plane coupler for printed circuit board-level optical interconnections. Whereas DPW is capable of rapidly fabricating high-quality master components, the technology is not suitable for low-cost mass fabrication. Therefore, we investigate the replication of out-of-plane coupling components using hot embossing, through the fabrication of a metal mould of the DPW master by applying electroplating. We compare these hot embossed replicas with components replicated using the elastomeric mould vacuum casting technology.

[1]  H. Thienpont,et al.  Laser ablation of parallel optical interconnect waveguides , 2006, IEEE Photonics Technology Letters.

[2]  G. Whitesides,et al.  Complex Optical Surfaces Formed by Replica Molding Against Elastomeric Masters , 1996, Science.

[3]  William S. Beich.  Injection molded polymer optics in the 21st Century , 2005, SPIE Optics + Photonics.

[4]  Jali Heilmann,et al.  Towards roll-to-roll fabrication of electronics, optics, and optoelectronics for smart and intelligent packaging , 2004, SPIE OPTO.

[5]  W. Bacher,et al.  Fabrication of LIGA mold inserts , 1998 .

[6]  Ljubomir Tanchev.  Virtual and Rapid Manufacturing : Advanced Research in Virtual and Rapid Prototyping , 2007 .

[7]  Ilkka Kallioniemi,et al.  Micro-optical modules fabricated by high-precision replication processes , 2002 .

[8]  M. Heckele,et al.  Review on micro molding of thermoplastic polymers , 2004 .

[9]  Y. S. Tarng,et al.  Determination of optimal cutting parameters in wire electrical discharge machining , 1995 .

[10]  M. Vervaeke,et al.  Deep proton writing: a rapid prototyping polymer micro-fabrication tool for micro-optical modules , 2006 .

[11]  D. Daly,et al.  Replication of optical components using a silicone rubber intermediate replica , 1997, Other Conferences.

[12]  M. Worgull,et al.  Modeling and optimization of the hot embossing process for micro- and nanocomponent fabrication , 2006 .

[13]  C. Debaes,et al.  Discrete Out-of-Plane Coupling Components for Printed Circuit Board-Level Optical Interconnections , 2007, IEEE Photonics Technology Letters.

[14]  Hans Peter Herzig,et al.  Simple technique for replication of micro-optical elements , 1998 .

[15]  J. Giboz,et al.  Microinjection molding of thermoplastic polymers: a review , 2007 .

[16]  Paulo Jorge da Silva Bartolo.  Innovative Developments in Design and Manufacturing: Advanced Research in Virtual and Rapid Prototyping - Proceedings of VR@P4, Oct. 2009, Leiria, Portugal , 2009 .