Impact of inlet distortion on turbocharger compressor stage performance

Abstract In a turbocharger system, curved pipes are usually used to connect compressors with other parts due to limited packaging space. It is well known that an elbow can generate flow distortion to and interact with the compressor inducer and therefore deteriorate compressor stage performance. The compressor efficiency change may vary with relative positions of inlet elbow and volute. The compressor’s stable flow range is also possible to vary due to the shift of surge and/or chock points. In this paper, eight relative circumferential positions between the inlet elbow and the volute were studied by 3D numerical simulations with experimental validations. The numerical results confirm that adjusting the inlet bend from one circumferential orientation to others does cause an obvious deviation in the compressor aerodynamic efficiency. The result also indicates that the total pressure deficit and the vortices at the compressor inlet are the main contributors to the compressor operating range. With the numerical findings in this paper which was validated by experimental measurements, it is suggested that unfavorable orientations of an elbow relative to volute should be avoided in an intake system.

[1]  Ce Yang,et al.  Stall inception induced by the volute tongue at centrifugal compressor inlet , 2017 .

[2]  Ben Zhao,et al.  Unsteady Flow Variability Driven by Rotor-stator Interaction at Rotor Exit , 2012 .

[3]  Hideaki Tamaki,et al.  Stability Improvement of High-Pressure-Ratio Turbocharger Centrifugal Compressor by Asymmetric Flow Control-Part I: Non-Axisymmetrical Flow in Centrifugal Compressor. , 2013, Journal of turbomachinery.

[4]  Koen Hillewaert,et al.  Numerical Simulation of Impeller–Volute Interaction in Centrifugal Compressors , 1998 .

[5]  Abraham Engeda,et al.  The influence of inlet flow distortion on the performance of a centrifugal compressor and the development of an improved inlet using numerical simulations , 2001 .

[6]  Lei Jin,et al.  Influence of volute-induced distortion on the performance of a high-pressure-ratio centrifugal compressor with a vaneless diffuser for turbocharger applications , 2014 .

[7]  Ce Yang,et al.  Non-axisymmetric flow characteristics in centrifugal compressor , 2015 .

[8]  Xinqian Zheng,et al.  Influence of the volute on the flow in a centrifugal compressor of a high-pressure ratio turbocharger , 2010 .

[9]  Seungjin Kim,et al.  Characteristics of Secondary Flow Induced by 90-Degree Elbow in Turbulent Pipe Flow , 2014 .

[10]  Lisa W. Griffin,et al.  Performance Improvement Through Indexing of Turbine Airfoils: Part 2 — Numerical Simulation , 1995 .

[11]  Abraham Engeda,et al.  A Numerical Investigation on the Volute/Impeller Steady-State Interaction due to Circumferential Distortion , 2001 .

[12]  Ben Zhao,et al.  Effects of Blade Counts and Clocking on the Unsteady Profile Pressure Distribution in an Axial-Radial Combined Compressor , 2013 .

[13]  R. A. Van den Braembussche,et al.  Experimental Investigation of the Circumferential Static Pressure Distortion in Centrifugal Compressor Stages , 1997 .

[14]  Fenghui Han,et al.  Influences of flow loss and inlet distortions from radial inlets on the performances of centrifugal compressor stages , 2016 .

[15]  Konrad Vogeler,et al.  Unsteady Blade Loading with Clocking in Multistage Axial Compressors, Part 1 , 2010 .

[16]  G. J. Walker,et al.  The Effect of Interaction Between Wakes From Blade Rows in an Axial Flow Compressor on the Noise Generated by Blade Interaction , 1972 .

[17]  P. D. Johnson,et al.  Performance Improvement Through Indexing of Turbine Airfoils: Part 1 — Experimental Investigation , 1995 .

[18]  Shan Chen,et al.  A novel clocking effect between inlet bend and volute in an automotive turbocharging system , 2016 .

[19]  Andrew M. Wo,et al.  Reduction of Unsteady Blade Loading by Beneficial Use of Vortical and Potential Disturbances in an Axial Compressor With Rotor Clocking , 1998 .

[20]  W. R. Dean,et al.  Note on the motion of fluid in a curved pipe , 1959 .

[21]  Thomas Povey,et al.  Effect of Low-NOX Combustor Swirl Clocking on Intermediate Turbine Duct Vane Aerodynamics With an Upstream High Pressure Turbine Stage—An Experimental and Computational Study , 2017 .

[22]  Albert J. Sanders,et al.  Rotor Blade-to-Blade Wake Variability and Effect on Downstream Vane Response , 2002 .

[23]  Bernd Stoffel,et al.  Experimental Investigation of the Clocking Effect in a 1.5-Stage Axial Turbine—Part II: Unsteady Results and Boundary Layer Behavior , 2009 .