Octagon Modelling Using Parallel Projection of Optical Tomography

This paper presents a hardware design, arrangement and measurement for optical tomography where optical tomography uses light sources as the transmitter and photodiodes as the receiver. By using parallel projection for 44 laser transmitters and photodiode receivers at the cross-sectional boundary, the existence of bubbles inside a vertical column pipeline is determined. Octagon modelling with an eight-sided jig is used for projection and the measurement method for this research is shown. An offline technique is used to collect readings from each signal and the image is reconstructed from the data received.

[1]  Daniil Kazantsev,et al.  Fan-beam tomography iterative algorithm based on Fourier transform , 2008, 2008 IEEE Nuclear Science Symposium Conference Record.

[2]  Ruzairi Abdul Rahim,et al.  Optical tomography system using microprocessor and ethernet controller‐based data acquisition system , 2010 .

[3]  Herlina Abdul Rahim,et al.  Modeling orthogonal and rectilinear mixed-modality projection of optical tomography for solid-particles concentration measurement , 2010 .

[4]  Uwe Hampel,et al.  Design of an optical tomograph for the investigation of single- and two-phase pipe flows , 2008 .

[5]  Sallehuddin Ibrahim,et al.  Optical Tomography Sensor Configuration for Estimating the Turbidity Level of Water , 2014 .

[6]  Dominique Toye,et al.  Possibilities and Limits of Application of Electrical Resistance Tomography in Hydrodynamics of Bubble Columns , 2008 .

[7]  Ruzairi Abdul Rahim,et al.  Ultrasonic Tomography System For Liquid/Gas Flow: Frame Rate Comparison Between Visual Basic And Visual C++ Programming , 2006 .

[8]  Ruzairi Abdul Rahim,et al.  Optical tomography sensor configuration using two orthogonal and two rectilinear projection arrays , 2005 .

[9]  Ruzairi Abdul Rahim,et al.  Criteria for sensor selection in optical tomography , 2009, 2009 IEEE Symposium on Industrial Electronics & Applications.

[10]  van Jr Ommen,et al.  Bubble size estimation in slurry bubble columns from pressure fluctuations , 2005 .

[11]  Ruzairi Abdul Rahim,et al.  Comparison between two different types of microcontroller in developing optical tomography controller unit , 2013 .

[12]  Nor Muzakkir Nor Ayob,et al.  Hardware Design of Laser Optical Tomography System for Detection of Bubbles Column , 2013 .

[14]  Naizatul Shima Mohd Fadzil,et al.  Study of the Effect of Brightness After Penetration of Light from a Lens , 2013 .