Aggregation and transport of copper oxide nanoparticles in porous media.

In this study, microscopic aggregates of copper oxide (CuO) nanoparticles were visualized in porous media for the first time. Two-dimensional microscopic visualization results showed that CuO aggregates formed in porous media regardless of flow velocity. The results demonstrated that flow velocity determined the density and location of aggregate deposition in porous media. The lower the flow velocity, the greater the number of aggregates deposited, and the larger the area of deposition-that is, it was not limited to the pore neck. Transport of CuO nanoparticles was also evaluated by comparing breakthrough curves at three different flow velocities. The higher the Darcy flow velocity, the more the CuO nanoparticles are discharged from the porous medium, and the less deposited they are within the medium. Surfactants significantly affected the fate and transport of CuO nanoparticles in porous media. Most of the CuO nanoparticles present in the surfactant solution flowed through the porous medium, while only 30% of the nanoparticles in water flowed through the medium. However, the results also demonstrated that some CuO aggregates did form, even in the presence of a surfactant.

[1]  Mark R Wiesner,et al.  Laboratory assessment of the mobility of nanomaterials in porous media. , 2004, Environmental science & technology.

[2]  K. Pennell,et al.  Influence of electrolyte species and concentration on the aggregation and transport of fullerene nanoparticles in quartz sands , 2008, Environmental toxicology and chemistry.

[3]  Nathalie Tufenkji,et al.  Correlation equation for predicting single-collector efficiency in physicochemical filtration in saturated porous media. , 2004, Environmental science & technology.

[4]  Pratim Biswas,et al.  Assessing the risks of manufactured nanomaterials. , 2006, Environmental science & technology.

[5]  Jamie R Lead,et al.  Nanomaterials in the environment: Behavior, fate, bioavailability, and effects , 2008, Environmental toxicology and chemistry.

[6]  Jillian F Banfield,et al.  Influence of surface potential on aggregation and transport of titania nanoparticles. , 2006, Environmental science & technology.

[7]  Mark R Wiesner,et al.  Velocity effects on fullerene and oxide nanoparticle deposition in porous media. , 2004, Environmental science & technology.

[8]  P. C. Hiemenz,et al.  Principles of colloid and surface chemistry , 1977 .

[9]  Linda M Abriola,et al.  Transport and retention of nanoscale C60 aggregates in water-saturated porous media. , 2008, Environmental science & technology.

[10]  Seung-Woo Jeong,et al.  Enhanced removal of DNAPL trapped in porous media using simultaneous injection of cosolvent with air: influencing factors and removal mechanisms. , 2003, Journal of Hazardous Materials.

[11]  H. Karlsson,et al.  Copper oxide nanoparticles are highly toxic: a comparison between metal oxide nanoparticles and carbon nanotubes. , 2008, Chemical research in toxicology.

[12]  C. Radke,et al.  A pore-level investigation of foam/oil interactions in porous media , 1990 .

[13]  Kurt D. Pennell,et al.  Investigation of the transport and deposition of fullerene (C60) nanoparticles in quartz sands under varying flow conditions. , 2008, Environmental science & technology.