Electromagnetic-thermal coupling applied to the analysis of the heat transfer in a traction motor

The paper is aimed at the coupling between the electromagnetic and thermal physical phenomena, applied to the investigation and analysis of the heat transfer in a typical traction motor. To start with, the heat transfer basis are recalled with emphasis on the convection phenomenon. A thermal-electrical analogy is established for the sake of an analytical investigation of the heat transfer in the stator of the studied traction motor. Such an investigation is extended to a FEA-based modelling of the heat transfer of the machine. Prior to do so, the machine Joule and iron losses are predicted. Then, an electromagnetic-thermal coupling is established where these losses behave as heat sources. The FEA results reveal high temperatures in different areas of the machine especially in the stator slots. Two cooling approaches are investigated, which are: (i) forced air in the rotor pockets, and (ii) a water-filled spiral tube mounted around the outer surface of the stator.

[1]  A. Boglietti,et al.  Iron Losses Prediction with PWM Supply Using Low and High Frequency Measurements: Analysis and Results Comparison , 2006, IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics.

[2]  R. Winterton,et al.  Technical notes: where did the Dittus and Boelter equation come from , 1998 .

[3]  Mohamed Gabsi,et al.  Thermal–Electromagnetic Analysis for Driving Cycles of Embedded Flux-Switching Permanent-Magnet Motors , 2012, IEEE Transactions on Vehicular Technology.

[4]  Nicola Bianchi,et al.  Design and feature investigation of an IPM motor dedicated to propulsion applications , 2012 .

[5]  Nicola Bianchi,et al.  Electromagnetic/Thermal Design Procedure of an Aerospace Electric Propeller , 2015, IEEE Transactions on Industry Applications.

[6]  David A. Lowther,et al.  The Modified Jiles–Atherton Model for the Accurate Prediction of Iron Losses , 2017, IEEE Transactions on Magnetics.

[7]  R. Kaczmarek,et al.  A general formula for prediction of iron losses under nonsinusoidal voltage waveform , 1995 .

[8]  Josua P. Meyer,et al.  Convective Heat Transfer Coefficients in Concentric Annuli , 2005 .

[9]  Claude Marchand,et al.  A coupled electromagnetic‐thermal model for the design of electric machines: Association of analytical and numerical approaches , 2007 .

[10]  C. Ragusa,et al.  Predicting loss in magnetic steels under arbitrary induction waveform and with minor hysteresis loops , 2004, IEEE Transactions on Magnetics.

[11]  A. Abdel-azim.  Fundamentals of Heat and Mass Transfer , 2011 .

[12]  Rosario Miceli,et al.  Efficiency enhancement of permanent-magnet synchronous motor drives by online loss minimization approaches , 2005, IEEE Transactions on Industrial Electronics.

[13]  David Howe,et al.  Prediction and Measurement of Iron Loss in a Short-Stroke, Single-Phase, Tubular Permanent Magnet Machine , 2010, IEEE Transactions on Magnetics.