Fuel moisture soft-sensor and its validation for the industrial BioPower 5 CHP plant

This paper presents a soft-sensor for on-line monitoring of fuel moisture in a furnace. The method utilizes combustion power estimation and a dynamic model of the secondary superheater. In addition, the time delays in detecting changes in moisture content of the fuel are small enough for the method to be used for controlling air and fuel feed and preventing steam and pressure oscillations. To verify the fuel moisture soft-sensor, experiments were performed at a BioPower 5 CHP plant, which utilizes BioGrate combustion technology for very wet biomass fuels with a moisture content as high as 65%. Finally, the results are analyzed and discussed.

[1]  Ingwald Obernberger,et al.  Modelling of grate combustion in a medium scale biomass furnace for control purposes , 2010 .

[2]  Karl Johan Åström,et al.  Drum-boiler dynamics , 2000, Autom..

[3]  Pekka Ahtila,et al.  Implications of process energy efficiency improvements for primary energy consumption and CO2 emissions at the national level , 2010 .

[4]  Sirkka-Liisa Jämsä-Jounela,et al.  Model predictive control utilizing fuel and moisture soft-sensors for the BioPower 5 combined heat and power (CHP) plant , 2014 .

[5]  Tuula A. Vahlman,et al.  On-line Analysis of Stack Gas Composition by a Low Resolution FT-IR Gas Analyzer , 1998 .

[6]  Sirkka-Liisa Jämsä-Jounela,et al.  Fuel-quality soft sensor using the dynamic superheater model for control strategy improvement of the Biopower 5 CHP plant , 2012 .

[7]  Jukka Kortela,et al.  Fuel quality soft-sensor for control strategy improvement of the Biopower 5 CHP plant , 2010, 2010 Conference on Control and Fault-Tolerant Systems (SysTol).

[8]  S Lu,et al.  Dynamic modelling and simulation of power plant systems , 1999 .

[9]  B. W. Hogg,et al.  Dynamic nonlinear modelling of power plant by physical principles and neural networks , 2000 .

[10]  Siaw Kiang Chou,et al.  A thermoeconomic analysis of biomass energy for trigeneration , 2010 .

[11]  Arto Marttinen,et al.  Modelling, Identification and Control of a Grate Boiler , 1985, 1985 American Control Conference.

[12]  U. Kortela,et al.  A New Control Concept for a Coal Power Plant , 1981 .

[13]  Sirkka-Liisa Jämsä-Jounela,et al.  Model predictive control for BioPower combined heat and power (CHP) plant , 2012 .

[14]  Shane Ward,et al.  Development of a prototype infrared reflectance moisture meter for milled peat , 2000 .

[15]  W L James,et al.  A microwave method for measuring moisture content, density, and grain angle of wood , 1985 .

[16]  Karin Markides,et al.  Using miniature diode array NIR spectrometers for analysing wood chips and bark samples in motion , 2000 .

[17]  Søren Knudsen Kær,et al.  Grate-firing of biomass for heat and power production , 2008 .

[18]  S. Okarnura,et al.  New Method for Moisture Content Measurement Using Phase Shifts at Two Microwave Frequencies , 2000, The Journal of microwave power and electromagnetic energy : a publication of the International Microwave Power Institute.

[19]  Erik Dahlquist,et al.  Methods for determination of moisture content in woodchips for power plants—a review , 2004 .

[20]  Sønnik Clausen,et al.  FTIR emission spectroscopy methods and procedures for real time quantitative gas analysis in industrial environments , 2002 .

[21]  Henrik Thunman,et al.  On-line monitoring of fuel moisture-content in biomass-fired furnaces by measuring relative humidity of the flue gases , 2011 .