Experimental analysis of flow and heat transfer in a miniature porous heat sink for high heat flux application

[1]  J. Darabi,et al.  Development of a chip-integrated micro cooling device , 2003, Microelectron. J..

[2]  T. Lu,et al.  Experimental research on convection heat transfer in sintered porous plate channels , 2004 .

[3]  F. Topin,et al.  About the use of fibrous materials in compact heat exchangers , 2004 .

[4]  Yongchang Ma,et al.  Boundary conditions and wall effect for forced convection heat transfer in sintered porous plate channels. , 2004 .

[5]  S.V. Garimella,et al.  Piezoelectric Fans Using Higher Flexural Modes for Electronics Cooling Applications , 2007, IEEE Transactions on Components and Packaging Technologies.

[6]  F. Durst,et al.  Selection and optimization of pin cross-sections for electronics cooling , 2007 .

[7]  Sheng Liu,et al.  A Microjet Array Cooling System for Thermal Management of High-Brightness LEDs , 2007, IEEE Transactions on Advanced Packaging.

[8]  I. Mudawar,et al.  Single-phase hybrid micro-channel/micro-jet impingement cooling , 2008 .

[9]  A. Walton,et al.  Two-phase flow instabilities in a silicon microchannels heat sink , 2009 .

[10]  V. Romanenkov,et al.  Loop heat pipe for cooling of high-power electronic components , 2009 .

[11]  K. Ng,et al.  Modeling and testing of an advanced compact two-phase cooler for electronics cooling , 2009 .

[12]  I. Mudawar,et al.  CHF determination for high-heat flux phase change cooling system incorporating both micro-channel flow and jet impingement , 2009 .

[13]  Kok-Cheong Wong,et al.  Numerical study of mixed convection on jet impingement cooling in a horizontal porous layer-using Brinkman-extended Darcy model , 2009 .

[14]  J. Thome,et al.  Saturated critical heat flux in a multi-microchannel heat sink fed by a split flow system , 2010 .

[15]  C. Shu,et al.  Fluid flow and heat transfer in wavy microchannels , 2010 .

[16]  Min-Soo Kim,et al.  Experimental study on microchannel heat sinks considering mass flow distribution with non-uniform heat flux conditions , 2010 .

[17]  K. Toh,et al.  Experimental study of impingement spray cooling for high power devices , 2010 .

[18]  Wei Li,et al.  A general criterion for evaporative heat transfer in micro/mini-channels , 2010 .

[19]  F. Tan,et al.  Cooling of portable hand-held electronic devices using phase change materials in finned heat sinks , 2010 .

[20]  B. Pulvirenti,et al.  Boiling heat transfer in narrow channels with offset strip fins: Application to electronic chipsets cooling , 2010 .

[21]  Yu-Wei Chang,et al.  Thermoelectric water-cooling device applied to electronic equipment , 2010 .

[22]  V. Selladurai,et al.  Mixed convection on jet impingement cooling of a constant heat flux horizontal porous layer , 2010 .