Laminated, sacrificial-poly MEMS technology in standard CMOS

[1]  A. M. Robinson,et al.  A new approach for the fabrication of micromechanical structures , 1989 .

[2]  A. Roosmalen,et al.  Dry Etching for VLSI , 1991 .

[3]  Wolfgang Kuehnel,et al.  A surface micromachined silicon accelerometer with on-chip detection circuitry , 1994 .

[4]  J. Gardeniers,et al.  Applications of fluorocarbon polymers in micromechanics and micromachining , 1994 .

[5]  M. W. Putty.  A Maicromachined vibrating ring gyroscope , 1994 .

[6]  Helmut Dr. Klose,et al.  Micromechanics compatible with an 0.8 μm CMOS process , 1995 .

[7]  Paul J. McWhorter,et al.  Embedded micromechanical devices for the monolithic integration of MEMS with CMOS , 1995, Proceedings of International Electron Devices Meeting.

[8]  R. Wolffenbuttel,et al.  SIMPLE — A technique of silicon micromachining using plasma etching , 1996 .

[9]  Christofer Hierold,et al.  A pure CMOS surface-micromachined integrated accelerometer , 1996 .

[10]  Noel C. MacDonald,et al.  Integrating SCREAM micromachined devices with integrated circuits , 1996, Proceedings of Ninth International Workshop on Micro Electromechanical Systems.

[11]  G. Fedder,et al.  Laminated high-aspect-ratio microstructures in a conventional CMOS process , 1996, Proceedings of Ninth International Workshop on Micro Electromechanical Systems.

[12]  P. Sarro,et al.  New silicon micromachining techniques for microsystems , 1997 .

[13]  K.-G. Oppermann,et al.  Full integration of a pressure-sensor system into a standard BiCMOS process , 1998 .

[14]  Bradley K. Smith,et al.  Thin Teflon-like films for eliminating adhesion in released polysilicon microstructures , 1998 .

[15]  Albert P. Pisano,et al.  Surface-micromachined 1MHz oscillator with low-noise Pierce configuration , 1998 .

[16]  R. Wolffenbuttel,et al.  Silicon ic process compatible thin metal film post-processing module , 1998 .

[17]  Bernhard E. Boser,et al.  A three-axis micromachined accelerometer with a CMOS position-sense interface and digital offset-trim electronics , 1999, IEEE J. Solid State Circuits.

[18]  G. Fedder,et al.  A lateral capacitive CMOS accelerometer with structural curl compensation , 1999, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[19]  Gary K. Fedder,et al.  ANALYSIS OF TEMPERATURE-DEPENDENT RESIDUAL STRESS GRADIENTS IN CMOS MICROMACHINED STRUCTURES , 1999 .