Arrayed Force Sensors Made of Paper, Elastomer, and Hydrogel Particles

This article presents a sensor for detecting the distribution of forces on a surface. The device with nine buttons consisted of an elastomer-based layer as a touch interface resting on a substrate of patterned metallized paper. The elastomer-based layer included a three-by-three array of deformable, hemispherical elements/reliefs, facing down toward an array of interdigitated capacitive sensing units on patterned metallized paper. Each hemispherical element is 20 mm in diameter and 8 mm in height. When a user applied pressure to the elastomer-based layer, the contact area between the hemispherical elements and the interdigitated capacitive sensing units increased with the deformation of the hemispherical elements. To enhance the sensitivity of the sensors, embedded particles of hydrogel in the elastomer-based layer increased the measured electrical responses. The measured capacitance increased because the effective dielectric permittivity of the hydrogel was greater than that of air. Electromechanical characterization verified that the hydrogel-filled elastomer was more sensitive to force at a low range of loads (23.4 pF/N) than elastomer alone without embedded hydrogel (3.4 pF/N), as the hydrogel reduced the effective elastic modulus of the composite material by a factor of seven. A simple demonstration suggests that the force-sensing array has the potential to contribute to wearable and soft robotic devices.

[1]  A. Vallbo,et al.  Activity from skin mechanoreceptors recorded percutaneously in awake human subjects. , 1968, Experimental neurology.

[2]  A. Minakata,et al.  Dielectric properties of polyelectrolytes. I. A study on tetra‐n‐butyl ammonium polyacrylate , 1972 .

[3]  Jari P. Kaipio,et al.  Tikhonov regularization and prior information in electrical impedance tomography , 1998, IEEE Transactions on Medical Imaging.

[4]  Gene H. Golub,et al.  Tikhonov Regularization and Total Least Squares , 1999, SIAM J. Matrix Anal. Appl..

[5]  Kenneth O. Johnson,et al.  The roles and functions of cutaneous mechanoreceptors , 2001, Current Opinion in Neurobiology.

[6]  Takao Someya,et al.  A large-area, flexible pressure sensor matrix with organic field-effect transistors for artificial skin applications. , 2004, Proceedings of the National Academy of Sciences of the United States of America.

[7]  Giulio Sandini,et al.  Tactile Sensing—From Humans to Humanoids , 2010, IEEE Transactions on Robotics.

[8]  Benjamin C. K. Tee,et al.  Highly sensitive flexible pressure sensors with microstructured rubber dielectric layers. , 2010, Nature materials.

[9]  Chun-Liang Lin,et al.  A Polymer-Based Capacitive Sensing Array for Normal and Shear Force Measurement , 2010, Sensors.

[10]  Rebecca K. Kramer,et al.  Hyperelastic pressure sensing with a liquid-embedded elastomer , 2010 .

[11]  Andrew G. Gillies,et al.  Nanowire active-matrix circuitry for low-voltage macroscale artificial skin. , 2010, Nature materials.

[12]  Benjamin C. K. Tee,et al.  Skin-like pressure and strain sensors based on transparent elastic films of carbon nanotubes. , 2011, Nature nanotechnology.

[13]  Raeed H. Chowdhury,et al.  Epidermal Electronics , 2011, Science.

[14]  Aaron D. Mazzeo,et al.  Paper‐Based, Capacitive Touch Pads , 2012, Advanced materials.

[15]  Yong-Lae Park,et al.  Design and Fabrication of Soft Artificial Skin Using Embedded Microchannels and Liquid Conductors , 2012, IEEE Sensors Journal.

[16]  T. Someya,et al.  Stretchable organic integrated circuits for large-area electronic skin surfaces , 2012 .

[17]  F. Topuz,et al.  Hydrogels in sensing applications , 2012 .

[18]  A. J. Steckl,et al.  Circuits on cellulose , 2013, IEEE Spectrum.

[19]  Zhibin Yu,et al.  User-interactive electronic skin for instantaneous pressure visualization. , 2013, Nature materials.

[20]  Rebecca K. Kramer,et al.  Masked Deposition of Gallium‐Indium Alloys for Liquid‐Embedded Elastomer Conductors , 2013 .

[21]  A paper-based piezoelectric touch pad integrating zinc oxide nanowires , 2014, 2014 IEEE 27th International Conference on Micro Electro Mechanical Systems (MEMS).

[22]  R. Dauskardt,et al.  An ultra-sensitive resistive pressure sensor based on hollow-sphere microstructure induced elasticity in conducting polymer film , 2014, Nature Communications.

[23]  A. Steckl,et al.  Pentacene organic thin-film transistors on flexible paper and glass substrates , 2014, Nanotechnology.

[24]  Yei Hwan Jung,et al.  Stretchable silicon nanoribbon electronics for skin prosthesis , 2014, Nature Communications.

[25]  Enas M. Ahmed,et al.  Hydrogel: Preparation, characterization, and applications: A review , 2013, Journal of advanced research.

[26]  Allister F. McGuire,et al.  A skin-inspired organic digital mechanoreceptor , 2015, Science.

[27]  Zhenan Bao,et al.  A chameleon-inspired stretchable electronic skin with interactive colour changing controlled by tactile sensing , 2015, Nature Communications.

[28]  Tongfen Liang,et al.  A flexible future for paper-based electronics , 2016, Defense + Security.

[29]  Sam Emaminejad,et al.  Fully integrated wearable sensor arrays for multiplexed in situ perspiration analysis , 2016, Nature.

[30]  J. M. Nassar,et al.  Paper Skin Multisensory Platform for Simultaneous Environmental Monitoring , 2016 .

[31]  Jung Woo Lee,et al.  Battery-free, stretchable optoelectronic systems for wireless optical characterization of the skin , 2016, Science Advances.

[32]  Zhenan Bao,et al.  Pursuing prosthetic electronic skin. , 2016, Nature materials.

[33]  Hyung Joon Shim,et al.  Wearable Electrocardiogram Monitor Using Carbon Nanotube Electronics and Color-Tunable Organic Light-Emitting Diodes. , 2017, ACS nano.

[34]  Aaron D. Mazzeo,et al.  Paper-based plasma sanitizers , 2017, Proceedings of the National Academy of Sciences.

[35]  T. Someya,et al.  Printable elastic conductors by in situ formation of silver nanoparticles from silver flakes. , 2017, Nature materials.