Numerical modelling of small supersonic axial flow turbines

Aki Grönman Numerical modelling of small supersonic axial flow turbines Lappeenranta 2010 102 pages Acta Universitatis Lappeenrantaensis 392 Diss. Lappeenranta University of Technology ISBN 978-952-214-953-4, ISBN 978-952-214-954-1 (PDF), ISSN 1456-4491 Supersonic axial turbine stages typically exhibit lower efficiencies than subsonic axial turbine stages. One reason for the lower efficiency is the occurrence of shock waves. With higher pressure ratios the flow inside the turbine becomes relatively easily supersonic if there is only one turbine stage. Supersonic axial turbines can be designed in smaller physical size compared to subsonic axial turbines of same power. This makes them good candidates for turbochargers in large diesel engines, where space can be a limiting factor. Also the production costs are lower for a supersonic axial turbine stage than for two subsonic stages. Since supersonic axial turbines are typically low reaction turbines, they also create lower axial forces to be compensated with bearings compared to high reaction turbines. The effect of changing the stator-rotor axial gap in a small high (rotational) speed supersonic axial flow turbine is studied in design and off-design conditions. Also the effect of using pulsatile mass flow at the supersonic stator inlet is studied. Five axial gaps (axial space between stator and rotor) are modelled using threedimensional computational fluid dynamics at the design and three axial gaps at the off-design conditions. Numerical reliability is studied in three independent studies. An additional measurement is made with the design turbine geometry at intermediate off-design conditions and is used to increase the reliability of the modelling. All numerical modelling is made with the Navier-Stokes solver Finflo employing Chien’s k − 2 turbulence model. The modelling of the turbine at the design and off-design conditions shows that the total-to-static efficiency of the turbine decreases when the axial gap is increased in both design and off-design conditions. The efficiency drops almost linearily at the off-design conditions, whereas the efficiency drop accelerates with increasing axial gap at the design conditions. The modelling of the turbine stator with pulsatile inlet flow reveals that the mass flow pulsation amplitude is decreased at the stator throat. The stator efficiency and pressure ratio have sinusoidal shapes as a function of time. A hysteresis-like behaviour is detected for stator efficiency and pressure ratio as a function of inlet mass flow, over one pulse period. This behaviour arises from the pulsatile inlet flow. It is important to have the smallest possible axial gap in the studied turbine type in order to maximize the efficiency. The results for the whole turbine can also be applied to some extent in similar turbines operating for example in space rocket engines. The use of a supersonic stator in a pulsatile inlet flow is shown to be possible.

[1]  Markku Ikävalko.  Contextuality in SME Ownership – Studies on Owner-managers’ Ownership Behavior , 2010 .

[2]  Daniel J. Dorney,et al.  Simulations of the unsteady flow through the Fastrac Supersonic Turbine , 2000 .

[3]  Jarno Kohonen.  Advanced chemometric methods: Applicability on industrial data , 2009 .

[4]  Teemu Turunen-Saaresti,et al.  Computational Study of a High-Expansion Ratio Radial Organic Rankine Cycle Turbine Stator , 2010 .

[5]  Bernhard Sendhoff,et al.  A Study of Advanced High Loaded Transonic Turbine Airfoils , 2004 .

[6]  John Waggott,et al.  Curtis Stage Nozzle/Rotor Aerodynamic Interaction and the Effect on Stage Performance , 2007 .

[7]  G. D. van Albada,et al.  A comparative study of computational methods in cosmic gas dynamics , 1982 .

[8]  P. Roe.  Approximate Riemann Solvers, Parameter Vectors, and Difference Schemes , 1997 .

[9]  Simo A. Nurmi.  Computational and Experimental Investigation of the Grooved Roll in Paper Machine Environment , 2009 .

[10]  Hideaki Sato,et al.  Experimental Studies on Aerodynamic Performance and Unsteady Flow Behaviors of a Single Turbine Stage With Variable Rotor-Stator Axial Gap: Comparisons With Time-Accurate Numerical Simulation , 2007 .

[11]  P. Ritala.  Coopetitive advantage – How firms create and appropriate value by collaborating with their competitors , 2010 .

[12]  J. Szwedowicz,et al.  Approach to Unidirectional Coupled CFD – FEM Analysis of Axial Turbocharger Turbine Blades , 2001 .

[13]  Antti Lindqvist,et al.  Engendering Group Support Based Foresight for Capital Intensive Manufacturing Industries - Case Paper and Steel Industry Scenarios by 2018 , 2009 .

[14]  Irina Rauvanto.  The intrinsic mechanisms of softwood fiber damage in brown stock fiber line unit operations Lappeenranta 2010 , 2010 .

[15]  Aki Grönman,et al.  Numerical modelling of a supersonic axial turbine stator , 2010 .

[16]  Ahti Jaatinen.  Performance Improvement of Centrifugal Compressor Stage with Pinched Geometry or Vaned Diffuser , 2009 .

[17]  Jim Turner,et al.  Effects of Endwall Geometry and Stacking on Two-Stage Supersonic Turbine Performance , 2002 .

[18]  Ricardo Martinez-Botas,et al.  Assessment of Unsteady Behavior in Turbocharger Turbines , 2006 .

[19]  Matti Juutilainen.  Towards open access networks – prototyping with the Lappeenranta model , 2009 .

[20]  Vincenzo Dossena,et al.  Investigation of the Flow Field in a HP Turbine Stage for Two Stator-Rotor Axial Gaps: Part I — 3D Time-Averaged Flow Field , 2006 .

[21]  I Hakeem,et al.  Effect of volute geometry on the steady and unsteady performance of mixed-flow turbines , 2007 .

[22]  Katri Sirola,et al.  Chelating Adsorbents in Purification of Hydrometallurgical Solutions , 2009 .

[23]  Lea Hannola.  Challenges and Means for the Front End Activities of Software Development , 2009 .

[24]  Tuomas Eerola.  Computational visual quality of digitally printed images , 2010 .

[25]  Srithar Rajoo,et al.  Unsteady Effect in a Nozzled Turbocharger Turbine , 2007 .

[26]  F. Martelli,et al.  Investigation of the Unsteady Rotor Aerodynamics in a Transonic Turbine Stage , 2000 .

[27]  Daniel J. Dorney,et al.  A Study of the Effects of Tip Clearance in a Supersonic Turbine , 2000 .

[28]  K. Chien,et al.  Predictions of Channel and Boundary-Layer Flows with a Low-Reynolds-Number Turbulence Model , 1982 .

[29]  Vincenzo Dossena,et al.  Investigation of the Flow Field in a HP Turbine Stage for Two Stator-Rotor Axial Gaps: Part II — Unsteady Flow Field , 2006 .

[30]  Kaisa Henttonen.  THE EFFECTS OF SOCIAL NETWORKS ON WORK-TEAM EFFECTIVENESS , 2009 .

[31]  Reza S. Abhari,et al.  Influence of Vane-Blade Spacing on Transonic Turbine Stage Aerodynamics: Part II — Time-Resolved Data and Analysis , 1998 .

[32]  Teemu Turunen-Saaresti.  Computational and Experimental Analysis of Flow Field in the Diffusers of Centrifugal Compressors , 2004 .

[33]  A. W. Reichert,et al.  Design and Flow Field Calculations for Transonic and Supersonic Radial Inflow Turbine Guide Vanes , 1995 .

[34]  Pekka Röyttä.  Study of a vapor-compression air-conditioning system for jetliners , 2009 .

[35]  O. Schafer.  Simulation of unsteady compressible flow in turbomachinery , 2002 .

[36]  Jin Tang,et al.  Experimental and Numerical Study of Real-Gas Flow in a Supersonic ORC Turbine Nozzle , 2006 .

[37]  Olli Alkkiomäki.  Sensor Fusion of Proprioception, Force and Vision in Estimation and Robot , 2009 .

[38]  U. Wahlen,et al.  Performance test results for the Vulcain 2 supersonic/transonic turbine , 1998 .

[39]  Douglas L. Sondak,et al.  Full and Partial Admission Performance of the Simplex Turbine , 2004 .

[40]  Laszlo Fuchs,et al.  Numerical computations of pulsatile flow in a turbo-charger , 2008 .

[41]  Douglas L. Sondak,et al.  Unsteady flow in a supersonic turbine with variable specific heats , 2001 .

[42]  Aki Grönman.  Ylisoonisen yksivaiheisen aksiaaliturbiinin suunnittelu , 2006 .

[43]  Arttu Reunanen,et al.  Experimental and Numerical Analysis of Different Volutes in a Centrifugal Compressor , 2001 .

[44]  Ricardo Martinez-Botas,et al.  The Pulsating Flow Field in a Mixed Flow Turbocharger Turbine: An Experimental and Computational Study , 2004 .

[45]  Antti Häkkinen,et al.  The influence of crystallization conditions on the filtration characteristics of sulphathiazole suspensions , 2009 .

[46]  Walter Traupel.  Thermodynamisch-strömungstechnische Berechnung , 1958 .

[47]  Risto Tiainen,et al.  Utilization of a Time Domain Simulator in the Technical and Economic Analysis of a Wind Turbine Electric Drive Train , 2010 .

[48]  Elisabeta-Cristina Ani.  Minimization of the experimental workload for the prediction of pollutants propagation in rivers. Mathematical modelling and knowledge re-use , 2009 .

[49]  Sonny Andersson.  A study of tolerance impact on performance of a supersonic turbine , 2007 .

[50]  Markus Jöcker,et al.  Numerical Investigation of the Aerodynamic Vibration Excitation of High-Pressure Turbine Rotors , 2002 .

[51]  Hanne Jussila,et al.  Concentrated Winding Multiphase Permanent Magnet Machine Design and Electromagnetic Properties – Case Axial Flux Machine , 2009 .

[52]  J. Anderson,et al.  Fundamentals of Aerodynamics , 1984 .

[53]  Katrina Lintukangas.  Supplier relationship management capability in the firm's global integration , 2009 .

[54]  Daniel J. Dorney,et al.  Simulations of the flow in supersonic turbines with straight centerline nozzles , 1999 .

[55]  Harri Auvinen,et al.  Inversion and assimilation methods with applications in geophysical remote sensing , 2009 .

[56]  Eunhwan Jeong,et al.  Effect of Nozzle-Rotor Clearance on Turbine Performance , 2006 .

[57]  N Karamanis,et al.  Mixed-flow turbines for automotive turbochargers: Steady and unsteady performance , 2002 .

[58]  Jani Rönkkönen.  ContinuousMultimodal Global Optimization with Differential Evolution-Based Methods , 2009 .

[59]  Kazutoyo Yamada,et al.  Influences of Axial Gap Between Blade Rows on Secondary Flows and Aerodynamic Performance in a Turbine Stage , 2009 .

[60]  Timo Siikonen,et al.  Numerical Simulation of Real-Gas Flow in a Supersonic Turbine Nozzle Ring , 2002 .

[61]  Anne Jalkala.  Customer reference marketing in a business to business context , 2009 .

[62]  E. Venkatapathy,et al.  Multi-dimensional formulation of CSCM - An upwind flux difference eigenvector split method for the compressible Navier-Stokes equations , 1983 .

[63]  Toni Itkonen.  Parallel-Operating Three-Phase Voltage Source Inverters – Circulating CurrentModeling, Analysis and Mitigation , 2010 .

[64]  Marko K. Matikainen,et al.  Development of beam and plate finite elements based on the absolute nodal coordinate formulation , 2009 .

[65]  Ali Hajilouy-Benisi,et al.  Performance Prediction of Twin-Entry Turbocharger Turbines , 2002 .

[66]  Pekka Pessi.  Novel Robot Solutions for Carrying out Field Joint Welding and Machining in the Assembly of the Vacuum Vessel of ITER , 2009 .

[67]  J. H. Horlock,et al.  A Comparison of the Performance of Three Model Axial Flow Turbines Tested under Both Steady and Pulse Flow Conditions , 1969 .

[68]  Annastiina Kerkkänen.  Improving demand forecasting practices in the industrial context , 2010 .

[69]  Kaisa Tahvanainen,et al.  Managing regulatory risks when outsourcing network-related services in the electricity distribution sector , 2010 .

[70]  Pieter Groth,et al.  Experimental and Computational Fluid Dynamics Based Determination of Flutter Limits in Supersonic Space Turbines , 2010 .

[71]  Hanna Salojärvi.  Customer knowledge processing in key account management , 2010 .

[72]  Diana Kalenova.  Color ad spectral image assessment using novel quality and fidelity techniques , 2009 .

[73]  Konstantin Lisunov.  Magnetic and transport properties of II-V diluted magnetic semiconductors doped with manganese and nickel , 2009 .

[74]  Jin Tang.  Computational Analysis and Optimization of Real Gas Flow In Small Centrifugal Compressors , 2006 .

[75]  Satu Pätäri,et al.  On Value Creation at an Industrial Intersection – Bioenergy in the Forest and Energy Sectors , 2009 .

[76]  P. Paolucci,et al.  The detector control systems for the CMS Resistive Plate Chamber , 2010 .

[77]  Jukka Lassila.  Strategic Development of Electricity Distribution Networks – Concept and Methods , 2009 .