Effect of torque tightening on the fatigue strength of bolted joints

Abstract The effect of tightening torques on the life of plates bolted using single and double lap joints was investigated. The effect of plate thickness using an aircraft grade aluminium alloy with double lap joints was also studied. Constant amplitude fatigue tests, under load control, were carried out, with a near zero stress ratio, on plain specimens (for bench mark purposes) and on both single and double lap joint specimens, for which several torque levels were applied on the bolted joints. The objective of the fatigue tests was to demonstrate failure trends for each joint type, material thickness and torque loading, rather than the generation of comprehensive S – N curves. Possible factors that affected the fatigue life of the bolted joints are discussed and conclusions are drawn with respect to the beneficial effects of tightening torques on the bolted single and double lap joints.

[1]  J. F. Williams,et al.  Analysis of cold-expansion for cracked and uncracked fastener holes , 1991 .

[2]  Paolo Lazzarin,et al.  A re-analysis on fatigue data of aluminium alloy bolted joints , 1997 .

[3]  Xiang Zhang,et al.  Life enhancement of fatigue-aged fastener holes using the cold expansion process , 2000 .

[4]  C. Cooper,et al.  Effects of joint geometry and bolt torque on the structural performance of single bolt tension joints in pultruded GRP sheet material , 1995 .

[5]  Wen-Hwa Chen,et al.  Three-dimensional contact stress analysis of a composite laminate with bolted joint , 1995 .

[6]  Walter J. Horn,et al.  Influence of Clamp-Up Force on the Strength of Bolted Composite Joints , 1994 .

[7]  Geoffrey L. Kulak,et al.  Guide to Design Criteria for Bolted and Riveted Joints , 1987 .

[8]  Ronald L. Huston,et al.  Practical Stress Analysis in Engineering Design , 1982 .

[9]  Dl Ball,et al.  Experimental investigation on the effects of cold expansion of fastener holes , 1998 .

[10]  H. Saunders,et al.  An Introduction to the Design and Behaviour of Bolted Joints , 1983 .

[11]  Joseph Edward Shigley,et al.  Mechanical engineering design , 1972 .

[12]  B. B. Mikic,et al.  Areas of contact and pressure distribution in bolted joints , 1972 .

[13]  B. Dattaguru,et al.  Analysis of a double shear lap joint with interference fit pin , 1995 .

[14]  Thomas Farris,et al.  Linking Riveting Process Parameters to the Fatigue Performance of Riveted Aircraft Structures , 2000 .

[15]  James Carvill,et al.  Mechanical Engineer's Data Handbook , 1993 .

[16]  Paolo Lazzarin,et al.  Scatter bands summarizing the fatigue strength of aluminium alloy bolted joints , 1997 .

[17]  John M. Potter,et al.  Fatigue in mechanically fastened composite and metallic joints : a symposium , 1986 .