Analysis of Transition Mode from Phase Shift to Zero-Phase Shift Under ZVS and NON-ZVS Operation for Induction Heating Inverter

This paper proposes an analysis of transition mode from phase shift to zero-phase shift under ZVS and NON-ZVS operation for a series resonant inverter with the load of induction heating. A number of circuit operation during transition mode from phase shift to zero-phase shift under ZVS and NON-ZVS conditions are first analyzed. Various voltage and current equations of the operating circuits are then obtained and used for calculation of the waveforms by the aid of MATLAB program. The calculated waveforms make possible the consideration of some important circuit parameters that are used to determine ZVS or NON-ZVS conditions. The theoretical results and proposed method are also verified by experimental ones, using a prototype test set in our laboratory.

[1]  J. A. Sabate,et al.  Design of a 10 kW, 500 kHz phase-shift controlled series-resonant inverter for induction heating , 1993, Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting.

[2]  J. Acero,et al.  Asymmetrical voltage-cancellation control for full-bridge series resonant inverters , 2004, IEEE Transactions on Power Electronics.

[3]  Yungtaek Jang,et al.  A new PWM ZVS full-bridge converter , 2007, Twenty-First Annual IEEE Applied Power Electronics Conference and Exposition, 2006. APEC '06..

[4]  F. C. Lee,et al.  Control system design and small-signal analysis of a phase-shift-controlled series-resonant inverter for induction heating , 1995, Proceedings of PESC '95 - Power Electronics Specialist Conference.

[5]  Kouki Matsuse,et al.  Analysis of Circuit Operation under ZVS and NON-ZVS Conditions in Phase-Shift Inverter for Induction Heating , 2006 .

[7]  J. A. Sabate,et al.  Effect of switch capacitance on zero-voltage switching of resonant converters , 1992, PESC '92 Record. 23rd Annual IEEE Power Electronics Specialists Conference.