A monolithic surface micromachined accelerometer with digital output

A surface micromachined accelerometer with on-chip electronics realized in a 3 /spl mu/m BiCMOS technology is described. The sensing element consists of a thin film of polysilicon that is deposited after fabrication of the electronic circuitry. Acceleration is measured by capacitively sensing sub-angstrom displacements of a mechanical proof-mass weighing 0.5 /spl mu/grams. The sensor uses force-feedback and achieves a resolution of 1.6 mg//spl radic/(Hz) (1 g=9.8 m/s/sup 2/). The limitations arising from the small size and mass of the sensing element and means for improvement are discussed. The small active die area of less than 3 mm/sup 2/ including the sensor along with the possibility to combine several different sensors on a single chip make this approach particularly attractive for applications demanding very small form factors.

[1]  M. Degrauwe,et al.  A Micropower CMOS-Instrumentation Amplifier , 1985, IEEE Journal of Solid-State Circuits.

[2]  R. Howe.  Surface micromachining for microsensors and microactuators , 1988 .

[3]  H. Jerman,et al.  Wide dynamic range direct accelerometer , 1990, IEEE 4th Technical Digest on Solid-State Sensor and Actuator Workshop.

[4]  L. Ristić,et al.  Surface micromachined polysilicon accelerometer , 1992, Technical Digest IEEE Solid-State Sensor and Actuator Workshop.

[5]  R. T. Howe,et al.  Quality factor control for micromechanical resonators , 1992, 1992 International Technical Digest on Electron Devices Meeting.

[6]  R. S. Payne,et al.  A low cost monolithic accelerometer; product/technology update , 1992, 1992 International Technical Digest on Electron Devices Meeting.

[7]  Roger T. Howe,et al.  Surface micromachined, digitally force-balanced accelerometer with integrated CMOS detection circuitry , 1992, Technical Digest IEEE Solid-State Sensor and Actuator Workshop.

[8]  S. Sherman,et al.  Fabrication technology for an integrated surface-micromachined sensor , 1993 .

[9]  L. J. Hornbeck,et al.  Current status of the digital micromirror device (DMD) for projection television applications , 1993, Proceedings of IEEE International Electron Devices Meeting.

[10]  T. Gabrielson.  Mechanical-thermal noise in micromachined acoustic and vibration sensors , 1993 .

[11]  M. Degrauwe,et al.  A 15 b electromechanical sigma-delta converter for acceleration measurements , 1994, Proceedings of IEEE International Solid-State Circuits Conference - ISSCC '94.

[12]  Rudy Van De Plassche.  Integrated analog-to-digital and digital-to-analog converters / Rudy Van De Plassche , 1994 .

[13]  Susumu Sugiyama,et al.  Micromachined sensors using polysilicon sacrificial layer etching technology , 1994, Proceedings of 1994 IEEE International Electron Devices Meeting.

[14]  J. Bustillo,et al.  Process technology for the modular integration of CMOS and polysilicon microstructures , 1994 .

[15]  Roger T. Howe,et al.  Surface micromachining: from vision to reality to vision [accelerometer] , 1995, Proceedings ISSCC '95 - International Solid-State Circuits Conference.

[16]  B. Boser,et al.  Surface micromachined accelerometers , 1995, Proceedings of the IEEE 1995 Custom Integrated Circuits Conference.