Backscattered microstructural noise in ultrasonic toneburst inspections

A model is presented which relates the absolute backscattered noise level observed in an ultrasonic immersion inspection to details of the measurement system and properties of the metal specimen under study. The model assumes that the backscattered noise signal observed for a given transducer position is an incoherent superposition of echoes from many grains. The model applies to normal-incidence, pulse-echo inspections of weakly-scattering materials using toneburst pulses from either a planar or focused transducer. The model can be used in two distinct ways. Measured noise echoes can be analyzed to deduce a “Figure-of-Merit” (FOM) which is a property of the specimen alone, and which parameterizes the contribution of the microstructure to the observed noise. If the FOM is known, the model can be used to predict the absolute noise levels that would be observed under various inspection scenarios. Tests of the model are reported, using both synthetic noise echoes, and measured noise echoes from metal specimens having simple and complicated microstructures.

[1]  T J Hall,et al.  Accurate depth-independent determination of acoustic backscatter coefficients with focused transducers. , 1989, The Journal of the Acoustical Society of America.

[2]  T J Hall,et al.  Tests of the accuracy of a data reduction method for determination of acoustic backscatter coefficients. , 1986, The Journal of the Acoustical Society of America.

[3]  Peter H. Rogers,et al.  An exact expression for the Lommel‐diffraction correction integral , 1974 .

[4]  R. B. Thompson,et al.  A Technique for Quantitatively Measuring Microstructurally Induced Ultrasonic Noise , 1991 .

[5]  J. H. Rose.  Ultrasonic backscatter from microstructure , 1992 .

[6]  R. B. Thompson,et al.  Monte-Carlo Simulation of Ultrasonic Grain Noise , 1993 .

[7]  J. Ogilvy.  Ultrasonic beam profiles and beam propagation in an austenitic weld using a theoretical ray tracing model , 1986 .

[8]  R. B. Thompson,et al.  Detectability of Small Flaws in Advanced Engine Alloys , 1993 .

[9]  P. Nagy,et al.  Scattering Induced Attenuation of Ultrasonic Backscattering , 1988 .

[10]  B. Auld.  General electromechanical reciprocity relations applied to the calculation of elastic wave scattering coefficients , 1979 .

[11]  Steven P. Neal,et al.  Grain noise power spectrum estimation for weak scattering polycrystalline materials using experimentally estimated backscatter coefficients: oblique incidence , 1994 .

[12]  T. A. Gray,et al.  Range of applicability of inversion algorithms , 1981 .

[13]  R. Bracewell.  The Fourier Transform and Its Applications , 1966 .

[14]  Irene A. Stegun,et al.  Handbook of Mathematical Functions. , 1966 .

[15]  E. F. Lopes,et al.  The effects of focusing and refraction on Gaussian ultrasonic beams , 1984 .

[16]  B. Tittmann,et al.  Attenuation and Grain Noise Parameters in Ni-Base Alloys , 1983 .

[17]  J. M. Pinkerton,et al.  A Pulse Method for the Measurement of Ultrasonic Absorption in Liquids: Results for Water , 1947, Nature.

[18]  Theory of Ultrasonic Backscatter From Multiphase Polycrystalline Solids , 1993 .

[19]  R. B. Thompson,et al.  A model relating ultrasonic scattering measurements through liquid–solid interfaces to unbounded medium scattering amplitudes , 1983 .

[20]  E. Madsen,et al.  Method of data reduction for accurate determination of acoustic backscatter coefficients. , 1984, The Journal of the Acoustical Society of America.

[21]  Frank J. Margetan,et al.  Microstructural noise in titanium alloys and its influence on the detectability of hard-alpha inclusions , 1992 .

[22]  T. A. Gray,et al.  Erratum: ‘‘A model relating ultrasonic scattering measurements through liquid–solid interfaces to unbounded medium scattering amplitudes’’ [J. Acoust. Soc. Am. 74, 1279–1290 (1983)] , 1984 .

[23]  Byron Newberry,et al.  A paraxial theory for the propagation of ultrasonic beams in anisotropic solids , 1989 .

[24]  Peter B. Nagy,et al.  Ultrasonic Attenuation Measurement by Backscattering Analysis , 1987 .

[25]  G. C. Johnson,et al.  A comparison of ultrasonic and X-ray determinations of texture in thin Cu and Al plates , 1989 .

[26]  I. Yalda-Mooshabad,et al.  Modeling Ultrasonic Microstructural Noise in Titanium Alloys , 1993 .

[27]  R. B. Thompson,et al.  Relations between elastic constants Cij and texture parameters for hexagonal materials , 1990 .