Microwave-assisted synthesis and characterization of tin oxide nanoparticles

Abstract Tin oxide nanoplatelets (SnO) and nanoparticles (SnO 2 ) were prepared by microwave assisted technique with an operating frequency of 2.45 GHz. This technique permits to produce gram quantity of homogeneous nanoparticles in just 10 min. The crystalline size was evaluated from XRD and found to range from 26 to 34 nm. SEM and TEM analyses showed that the nanoparticles present a platelet-like shaped particle or, a pseudo spherical morphology, after calcination at moderate temperature during which the phase transformation from SnO to SnO 2 takes place. Additional FT-IR, density and resistivity measurements were also presented.

[1]  Udo Weimar,et al.  Analysis of the noble metal catalytic additives introduced by impregnation of as obtained SnO2 sol–gel nanocrystals for gas sensors , 2000 .

[2]  Giovanni Neri,et al.  Nonaqueous synthesis of nanocrystalline semiconducting metal oxides for gas sensing. , 2004, Angewandte Chemie.

[3]  D. Lee,et al.  XRD and TEM studies on tin oxide (II) nanoparticles prepared by inert gas condensation , 2004 .

[4]  Joseph K. L. Lai,et al.  Grain growth in nanocrystalline SnO2 prepared by sol-gel route , 1999 .

[5]  S. T. Lakshmikumar,et al.  Study of the electronic and optical bonding properties of doped SnO2 , 2006 .

[6]  M. Antonietti,et al.  Non‐Aqueous Synthesis of High‐Purity Metal Oxide Nanopowders Using an Ether Elimination Process , 2004 .

[7]  Doron Aurbach,et al.  Nanoparticles of SnO produced by sonochemistry as anode materials for rechargeable lithium batteries , 2002 .

[8]  A. Alivisatos Perspectives on the Physical Chemistry of Semiconductor Nanocrystals , 1996 .

[9]  Rashmi,et al.  Gas sensing properties of nanocrystalline SnO2 prepared in solvent media using a microwave assisted technique , 2007 .

[10]  Yue-hua Hu,et al.  Synthesis of tin oxide nanoparticles by mechanochemical reaction , 2004 .

[11]  T. Tsuzuki,et al.  SnO2 nanoparticles prepared by mechanochemical processing , 2001 .

[12]  N. Bârsan,et al.  Grain size control in nanocrystalline In2O3 semiconductor gas sensors , 1997 .

[13]  S. Tasaka,et al.  The interfacial tension and morphology of reactive polymer blends , 2001 .

[14]  Rashmi,et al.  Study of structural and microstructural properties of SnO2 powder for LPG and CNG gas sensors , 2006 .

[15]  V. Brynzari,et al.  Electrical behavior of SnO2 thin films in humid atmosphere , 1999 .

[16]  Yung-Jen Lin,et al.  The properties of antimony-doped tin oxide thin films from the sol-gel process , 1997 .

[17]  F. Kruis,et al.  Surface oxidation of monodisperse SnOx nanoparticles , 2003 .

[18]  Ki Chang Song,et al.  Preparation of high surface area tin oxide powders by a homogeneous precipitation method , 2000 .

[19]  L. Fraigi,et al.  Comparison between two combustion routes for the synthesis of nanocrystalline SnO2 powders , 2001 .

[20]  Xianluo Hu,et al.  Sonochemical and microwave-assisted synthesis of linked single-crystalline ZnO rods , 2004 .

[21]  Ki Chang Song,et al.  Synthesis of high surface area tin oxide powders via water-in-oil microemulsions , 2000 .

[22]  M. Artemyev,et al.  Electroluminescence in thin solid films of closely packed CdS nanocrystals , 1997 .

[23]  Neng Guo,et al.  Solvothermal preparation and morphological evolution of stannous oxide powders , 2001 .

[24]  D. Briand,et al.  Pd-doped SnO2 thin films deposited by assisted ultrasonic spraying CVD for gas sensing: selectivity and effect of annealing , 1998 .

[25]  L. Gao,et al.  Synthesis and characterization of antimony-doped tin oxide (ATO) nanoparticles by a new hydrothermal method , 2004 .

[26]  C. Granqvist,et al.  Transparent and conducting ITO films: new developments and applications , 2002 .

[27]  Arie Zaban,et al.  Nanoporous SnO2 electrodes for dye-sensitized solar cells: improved cell performance by the synthesis of 18 nm SnO2 colloids , 2002 .

[28]  A. Alivisatos,et al.  Improved efficiencies in light emitting diodes made with CdSe(CdS) core/shell type nanocrystals and a semiconducting polymer , 1997 .

[29]  Angel Diéguez,et al.  Microwave processing for the low cost, mass production of undoped and in situ catalytic doped nanosized SnO2 gas sensor powders , 2000 .

[30]  Udo Weimar,et al.  A.c. measurements on tin oxide sensors to improve selectivities and sensitivities , 1995 .

[31]  Zhong Lin Wang,et al.  Springs, rings, and spirals of rutile-structured tin oxide nanobelts. , 2006, Journal of the American Chemical Society.

[32]  G. Zeng,et al.  Study on the microstructure and properties of nanosized stannic oxide powders , 1997 .

[33]  Norman Herron,et al.  Nanometer-sized semiconductor clusters: materials synthesis, quantum size effects, and photophysical properties , 1991 .

[34]  A. Cornet,et al.  Properties of nanocrystalline SnO2 obtained by means of a microwave process , 2001 .

[35]  K. Hashimoto,et al.  Photocatalysis and Photoinduced Hydrophilicity of Various Metal Oxide Thin Films , 2002 .

[36]  S. Akbar,et al.  Solid‐State Gas Sensors: A Review , 1992 .

[37]  S. Morrison,et al.  Semiconductor gas sensors , 1985 .

[38]  A. Maldonado,et al.  Physical properties of ZnO:F obtained from a fresh and aged solution of zinc acetate and zinc acetylacetonate , 2006 .

[39]  N. Yamazoe New approaches for improving semiconductor gas sensors , 1991 .

[40]  A. Venkataraman,et al.  Adsorption study of Pb2+ ions on nanosized SnO2, synthesized by self-propagating combustion reaction , 2004 .

[41]  Jai Kyeong Kim,et al.  Solid-state photovoltaic devices based on perylene acid-sensitized nanostructural SnO2 with P(VdF-co-HFP) gel electrolyte , 2006 .