论文信息 - Label Switched Path (LSP) Ping and Traceroute Multipath Support for Link Aggregation Group (LAG) Interfaces

Label Switched Path (LSP) Ping and Traceroute Multipath Support for Link Aggregation Group (LAG) Interfaces

This document defines extensions to the MPLS Label Switched Path (LSP) Ping and Traceroute mechanisms as specified in RFC 8029. The extensions allow the MPLS LSP Ping and Traceroute mechanisms to discover and exercise specific paths of Layer 2 (L2) Equal-Cost Multipath (ECMP) over Link Aggregation Group (LAG) interfaces. Additionally, a mechanism is defined to enable determination of the capabilities of an LSR supported. This document updates RFC8029.

[1] Wesley George,et al. Gap Analysis for Operating IPv6-Only MPLS Networks , 2015, RFC.

[2] Virtual Bridged,et al. IEEE Standards for Local and Metropolitan Area Networks: Specification for 802.3 Full Duplex Operation , 1997, IEEE Std 802.3x-1997 and IEEE Std 802.3y-1997 (Supplement to ISO/IEC 8802-3: 1996/ANSI/IEEE Std 802.3, 1996 Edition).

[3] Sam Aldrin,et al. IANA Registries for LSP Ping Code Points , 2015, RFC.

[4] Kireeti Kompella,et al. Detecting Multi-Protocol Label Switched (MPLS) Data Plane Failures , 2006, RFC.

[5] Scott O. Bradner,et al. Key words for use in RFCs to Indicate Requirement Levels , 1997, RFC.

[6] Kireeti Kompella,et al. Mechanism for Performing Label Switched Path Ping (LSP Ping) over MPLS Tunnels , 2011, RFC.