Influence of electromagnetic interferences on the mass sensitivity of Love mode surface acoustic wave sensors

Surface acoustic waveguides have found an application for (bio)chemical detection. The mass modification due to surface adsorption leads to measurable changes in the propagation properties of the waveguide. Among a wide variety of waveguides, the Love mode device has been investigated because of its high mass sensitivity. The acoustic signal launched and detected in the waveguide by electrical transducers is accompanied by an electromagnetic wave; the interaction of the two signals, easily enhanced by the open structure of the sensor, creates interference patterns in the transfer function of the sensor. The interference peaks are used to determine the sensitivity of the acoustic device. We show that electromagnetic interferences generate a distortion in the experimental value of the sensitivity. This distortion is not identical for the two classical instrumentation of the sensor that are the open and the closed loop configurations. Our theoretical approach is completed by the experimentation of an actual Love mode sensor operated under liquid conditions and in an open loop configuration. The experiment indicates that the interaction depends on frequency and mass modifications. (C) 2004 Elsevier B.V. All rights reserved.

[1]  Electra Gizeli,et al.  Comparison of Poly(methylmethacrylate) and Novolak waveguide coatings for an acoustic biosensor , 2001 .

[2]  Jean-Michel Friedt,et al.  Combined atomic force microscope and acoustic wave devices: Application to electrodeposition , 2003 .

[3]  Wojtek Wlodarski,et al.  Novel Love mode surface acoustic wave based immunosensors , 2003 .

[4]  S. Buttgenbach,et al.  Properties of sensors based on shear-horizontal surface acoustic waves in LiTaO/sub 3//SiO/sub 2/ and quartz/SiO/sub 2/ structures , 2001, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[5]  Jean-Michel Friedt,et al.  An SU-8 liquid cell for surface acoustic wave biosensors , 2004, SPIE Photonics Europe.

[6]  Electra Gizeli,et al.  Design considerations for the acoustic waveguide biosensor , 1997 .

[7]  C. K. Jen,et al.  Sensitivity analysis for Love mode acoustic gravimetric sensors , 1994 .

[8]  Bernhard Jakoby,et al.  Properties of Love waves: applications in sensors , 1997 .

[9]  Richard M. White,et al.  DIRECT PIEZOELECTRIC COUPLING TO SURFACE ELASTIC WAVES , 1965 .

[10]  Marc Lethiecq,et al.  Sensitivities of surface acoustic wave sensors based on fine grain ceramics , 1996, Quality Measurement: The Indispensable Bridge between Theory and Reality (No Measurements? No Science! Joint Conference - 1996: IEEE Instrumentation and Measurement Technology Conference and IMEKO Tec.

[11]  B. Auld,et al.  Acoustic fields and waves in solids , 1973 .

[12]  G. L. Harding,et al.  Love wave acoustic immunosensor operating in liquid , 1997 .

[13]  J. Vossen,et al.  Thin Film Processes , 1979 .

[14]  S Büttgenbach,et al.  Properties of sensors based on shear-horizontal surface acoustic waves in LiTaO3/SiO2 and quartz/SiO2 structures. , 2001, IEEE transactions on ultrasonics, ferroelectrics, and frequency control.

[15]  C. Campbell.  Surface Acoustic Wave Devices and Their Signal Processing Applications , 1989 .

[16]  Glen McHale,et al.  Mass sensitivity of acoustic wave devices from group and phase velocity measurements , 2002 .

[17]  G. L. Harding,et al.  Mass sensitivity of Love-mode acoustic sensors incorporating silicon dioxide and silicon-oxy-fluoride guiding layers , 2001 .