Atomic structure of the Fe/Fe3C interface with the Isaichev orientation in pearlite

Abstract The pronounced mechanical property of pearlitic steels highly correlates with the ferrite (bcc-Fe)/cementite (Fe3C) boundaries inside. Unraveling the interface structure at an atomic level is essential for interpreting the material’s property. In the present study, using aberration-corrected scanning/transmission electron microscopy combined with density functional theory calculations, we reveal the atomic configuration as well as the electronic structure of the Fe/Fe3C interfaces with the Isaichev orientation in pearlite. The interface with terminating layer Fe–C–Fe in cementite has the lowest energy due to the formation of interfacial Fe–C bonds. Terrace steps which are frequently observed at the interfaces would not break the lattice match between the two phases.

[1]  C. Weinberger,et al.  Atomistic investigation into the atomic structure and energetics of the ferrite-cementite interface: The Bagaryatskii orientation , 2016 .

[2]  C. Borchers,et al.  Cold-drawn pearlitic steel wires , 2016 .

[3]  X. Shao,et al.  Deformation twinning induced decomposition of lamellar LPSO structure and its re-precipitation in an Mg-Zn-Y alloy , 2016, Scientific Reports.

[4]  B. Wu,et al.  Atomic imaging of the interface between M23C6-type carbide and matrix in a long-term ageing polycrystalline Ni-based superalloy , 2015 .

[5]  Shijie Cao,et al.  Ligand modified nanoparticles increases cell uptake, alters endocytosis and elevates glioma distribution and internalization , 2013, Scientific Reports.

[6]  Patricia O. Dickerson,et al.  Plastic instability mechanisms in bimetallic nanolayered composites , 2014 .

[7]  M. Herbig,et al.  Segregation stabilizes nanocrystalline bulk steel with near theoretical strength. , 2014, Physical review letters.

[8]  I. Beyerlein,et al.  Engineering Interface Structures and Thermal Stabilities via SPD Processing in Bulk Nanostructured Metals , 2014, Scientific Reports.

[9]  I. Beyerlein,et al.  Interface-dependent nucleation in nanostructured layered composites , 2013 .

[10]  I. Beyerlein,et al.  Interface-driven microstructure development and ultra high strength of bulk nanostructured Cu-Nb multilayers fabricated by severe plastic deformation , 2013 .

[11]  I. Beyerlein,et al.  High-strength and thermally stable bulk nanolayered composites due to twin-induced interfaces , 2013, Nature Communications.

[12]  J. M. Wang,et al.  Zhang et al. reply , 2004, Nature.

[13]  Jian Wang,et al.  Atomic-scale study of nucleation of dislocations from fcc–bcc interfaces , 2012 .

[14]  D. Raabe,et al.  Atomic-scale mechanisms of deformation-induced cementite decomposition in pearlite , 2011 .

[15]  Qing Liu,et al.  Microstructure and strengthening mechanisms in cold-drawn pearlitic steel wire , 2011 .

[16]  C. Borchers,et al.  Partially amorphous nanocomposite obtained from heavily deformed pearlitic steel , 2009 .

[17]  Fujio Izumi,et al.  VESTA: a three-dimensional visualization system for electronic and structural analysis , 2008 .

[18]  M. Demkowicz,et al.  Interface structure and radiation damage resistance in Cu-Nb multilayer nanocomposites. , 2008, Physical review letters.

[19]  Wei Liu,et al.  Nial(110)/cr(110) interface : A density functional theory study , 2006 .

[20]  Lei Lu,et al.  Ultrahigh Strength and High Electrical Conductivity in Copper , 2004, Science.

[21]  Amit Misra,et al.  Single-dislocation-based strengthening mechanisms in nanoscale metallic multilayers , 2002 .

[22]  M. Zelin.  Microstructure evolution in pearlitic steels during wire drawing , 2002 .

[23]  C. Koch.  Determination of core structure periodicity and point defect density along dislocations , 2002 .

[24]  G. Kresse,et al.  From ultrasoft pseudopotentials to the projector augmented-wave method , 1999 .

[25]  D. Srolovitz,et al.  Misfit effects in adhesion calculations , 1998 .

[26]  Burke,et al.  Generalized Gradient Approximation Made Simple. , 1996, Physical review letters.

[27]  G. Kresse,et al.  Efficiency of ab-initio total energy calculations for metals and semiconductors using a plane-wave basis set , 1996 .

[28]  Blöchl,et al.  Improved tetrahedron method for Brillouin-zone integrations. , 1994, Physical review. B, Condensed matter.

[29]  J. Beynon,et al.  Microstructure and wear resistance of pearlitic rail steels , 1993 .

[30]  E. Yelsukov,et al.  Mössbauer study of magnetic properties formation in disordered Fe-Al alloys , 1992 .

[31]  D. S. Zhou,et al.  Ferrite: Cementite crystallography in pearlite , 1992 .

[32]  D. S. Zhou,et al.  Interfacial steps and growth mechanism in ferrous pearlites , 1991 .

[33]  F. H. Sanchez,et al.  NMR studies in orthorhombic Fe3B1−xCx (0.1≤x≤0.4) , 1987 .

[34]  H. Monkhorst,et al.  SPECIAL POINTS FOR BRILLOUIN-ZONE INTEGRATIONS , 1976 .