Signal-to-Noise Ratio, Dynamic Range, and Power Dissipation: Paying Attention to Their Interrelation Can Greatly Benefit Analog Circuit Design

Low power dissipation is paramount in an increasing number of applications. These notably include the Internet of Things and wireless sensor networks, in which a battery must last a very long time (even ten years in some cases) or in which energy harvesting is used. Battery life is also a key consideration in more traditional applications such as hearing aids and communication devices. All of these applications involve analog signals and require careful micropower circuit design. Such design can be more efficient if guided by an understanding of the fundamental limits [1]-[4], beyond which nature does not allow us to go. In this article, we review the relation between power dissipation and signal-to-noise ratio (SNR) for analog circuits. We make a crucial distinction between SNR and usable dynamic range (UDR) and review ways to allow the SNR to vary as needed, thus extending the UDR and resulting in adaptive power dissipation.

[1]  T.H. Lee,et al.  Oscillator phase noise: a tutorial , 1999, IEEE Journal of Solid-State Circuits.

[2]  P. R. Gray,et al.  Switched-capacitor high-Q bandpass filters for IF applications , 1986 .

[3]  Klaas Bult.  The Effect of Technology Scaling on Power Dissipation in Analog Circuits , 2006 .

[4]  Y. Tsividis,et al.  A Blocker-Vigilant Channel-Select Filter with Adaptive IIP3 and Power Dissipation , 2006, 2006 IEEE International Solid State Circuits Conference - Digest of Technical Papers.

[5]  Robert G. Meyer,et al.  Analysis and Design of Analog Integrated Circuits , 1993 .

[6]  Rinaldo Castello,et al.  Performance limitations in switched-capacitor filters , 1985 .

[7]  Peter R. Kinget,et al.  Integrated GHz Voltage Controlled Oscillators , 1999 .

[8]  Gabor C. Temes.  Autozeroing and correlated double sampling techniques , 1995 .

[9]  M. E. Valkenburg,et al.  Design of Analog Filters , 2001 .

[10]  Peter R. Kinget,et al.  Scaling analog circuits into deep nanoscale CMOS: Obstacles and ways to overcome them , 2015, 2015 IEEE Custom Integrated Circuits Conference (CICC).

[11]  Yannis Tsividis,et al.  Frequency-Dynamic Range-Power , 2002 .

[12]  Yorgos Palaskas,et al.  Internally varying analog circuits minimize power dissipation , 2003 .

[13]  P.R. Kinget.  Device mismatch and tradeoffs in the design of analog circuits , 2005, IEEE Journal of Solid-State Circuits.

[14]  K. Wada,et al.  A 0.6-V Dynamic Biasing Filter With 89-dB Dynamic Range in 0.18-$\mu$ m CMOS , 2009, IEEE Journal of Solid-State Circuits.

[15]  H. Nyquist.  Thermal Agitation of Electric Charge in Conductors , 1928 .

[16]  Asad A. Abidi,et al.  Adaptive analog IF signal processor for a wide-band CMOS wireless receiver , 2001 .

[17]  R. Stephenson.  A and V , 1962, The British journal of ophthalmology.

[18]  D. Sherrington.  Stochastic Processes in Physics and Chemistry , 1983 .

[19]  G. Groenewold.  The design of high dynamic range continuous-time integratable bandpass filters , 1991 .

[20]  Asad A. Abidi.  Noise in active resonators and the available dynamic range , 1992 .

[21]  Eric A. Vittoz,et al.  Future of analog in the VLSI environment , 1990, IEEE International Symposium on Circuits and Systems.

[22]  A. Hajimiri,et al.  Jitter and phase noise in ring oscillators , 1999, IEEE J. Solid State Circuits.

[23]  Gabor C. Temes,et al.  Circuit techniques for reducing the effects of op-amp imperfections: autozeroing, correlated double sampling, and chopper stabilization , 1996, Proc. IEEE.

[24]  Y. Tsividis,et al.  Dynamically biased 1 MHz low-pass filter with 61 dB peak SNR and 112 dB input range , 2001, 2001 IEEE International Solid-State Circuits Conference. Digest of Technical Papers. ISSCC (Cat. No.01CH37177).

[25]  C. Mead,et al.  White noise in MOS transistors and resistors , 1993, IEEE Circuits and Devices Magazine.

[26]  B.J. Hosticka,et al.  Performance comparison of analog and digital circuits , 1985, Proceedings of the IEEE.

[27]  Aarnout Brombacher,et al.  Probability... , 2009, Qual. Reliab. Eng. Int..