Compression tests of longitudinally stiffened plates undergoing distortional buckling

Abstract This paper describes a series of compression tests performed on longitudinally stiffened plates fabricated from a mild steel plate of thickness of 4.0 mm with nominal yield stress of 235.0 MPa. The stiffened plates with longitudinal stiffeners of a range of rigidities were tested to failure. The ultimate strengths and performances of the longitudinally stiffened plates in compression undergoing distortional buckling or interaction between local and distortional buckling were investigated experimentally and theoretically. The compression tests indicated that the critical buckling mode was dependent mainly on the rigidity of the longitudinal stiffeners and the width-to-thickness ratio of the sub-panels. A noticeable interaction between local and distortional buckling was also observed for some stiffened plates. A significant post-buckling strength reserve was shown for those sections with distortional buckling and for those sections showing interaction between local and distortional buckling. A limiting strength curve for distortional buckling of longitudinally stiffened plates was studied. Simple design strength formulas in the direct strength method are proposed to account for the distortional buckling and the interaction between local and distortional buckling of longitudinally stiffened plates. The strength curves were compared with the test and FE results conducted. The adequacy of the strength curve was confirmed. A set of conclusions on the buckling behavior of longitudinally stiffened plates was drawn from the experimental studies.

[1]  Teoman T Peköz,et al.  Direct Strength Prediction of Cold-formed Steel Members Using Numerical Elastic Buckling Solutions , 1998 .

[2]  Chai H. Yoo,et al.  Strength of Stiffened Flanges in Horizontally Curved Box Girders , 2005 .

[3]  Gregory J. Hancock,et al.  Compression Tests of High Strength Steel Channel Columns with Interaction between Local and Distortional Buckling , 2004 .

[4]  Gregory J. Hancock.  LOCAL DISTORTIONAL AND LATERAL BUCKLING OF I-BEAMS , 1978 .

[5]  Young Bong Kwon,et al.  Compression tests of welded section columns undergoing buckling interaction , 2007 .

[6]  Gregory J. Hancock,et al.  Development of the 2005 Edition of the Australian/New Zealand Standard for Cold-Formed Steel Structures AS/NZS 4600 , 2008 .

[7]  A. C. Walker.  Design and analysis of cold-formed sections , 1975 .

[8]  Chai H. Yoo,et al.  Stiffness Requirements for Longitudinally Stiffened Box-Girder Flanges , 2001 .

[9]  Gregory J. Hancock,et al.  Buckling of thin flat-walled structures by a spline finite strip method , 1986 .

[10]  Beatrice Gralton,et al.  Washington DC - USA , 2008 .

[11]  Chai H. Yoo,et al.  Experimental study of inelastic buckling strength and stiffness requirements for longitudinally stiffened panels , 2009 .

[12]  Young Bong Kwon,et al.  Compression tests of high strength cold-formed steel channels with buckling interaction , 2009 .

[13]  Gregory J. Hancock,et al.  TESTS OF COLD-FORMED CHANNELS WITH LOCAL AND DISTORTIONAL BUCKLING , 1992 .

[14]  Lawrance Hurst,et al.  Thin-Walled Structures: Research and Development , 2000 .