A LSNA configured to perform baseband engineering for device linearity investigations under modulated excitations

A Large Signal Network Analyzer (LSNA) system has been configured to automatically engineer specific baseband voltage waveforms that, when injected into the output of an active device enable novel device linearization investigations. This is achieved using a formulation, generalized in the envelope domain, to describe the required baseband injection voltage. The advantage of this formulation is that it can be used to compute and then engineer the required baseband injection voltage signals, for arbitrary amplitude modulated envelopes, in terms of a limited set of describing coefficients. Using this approach, it is possible to determine the optimum baseband signal coefficients necessary to linearize a 10W Cree GaN HEMT device using baseband injection techniques. The formulation is validated by experimental investigation, using a 3-tone modulated signal, where the optimum output baseband signal for third and fifth order IMD suppression is successfully identified. For the optimum case, the observed level of IM3 and IM5 distortion was reduced to less than -56dBc whilst driving into 1.5 dB of compression.

[1]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[2]  Chi-Shuen Leung,et al.  A new approach to amplifier linearization by the generalized baseband signal injection method , 2002, IEEE Microwave and Wireless Components Letters.

[3]  G.T. Zhou,et al.  Effects of even-order nonlinear terms on predistortion linearization , 2002, Proceedings of 2002 IEEE 10th Digital Signal Processing Workshop, 2002 and the 2nd Signal Processing Education Workshop..

[4]  Jose C. Pedro,et al.  Intermodulation Distortion in Microwave and Wireless Circuits , 2003 .

[5]  Timo Rahkonen,et al.  Distortion in RF power amplifiers , 2003 .

[6]  Andrei Grebennikov,et al.  RF and Microwave Power Amplifier Design , 2004 .

[7]  David E. Root,et al.  Fundamentals of Nonlinear Behavioral Modeling for RF and Microwave Design , 2005 .

[8]  L. Larson,et al.  Analysis of envelope signal injection for improvement of RF amplifier intermodulation distortion , 2005, IEEE J. Solid State Circuits.

[9]  P. J. Tasker,et al.  An enhanced modulated waveform measurement system for the robust characterization of microwave devices under modulated excitation , 2011, 2011 6th European Microwave Integrated Circuit Conference.

[10]  P. J. Tasker,et al.  Linearity improvement in RF power amplifier system using integrated Auxiliary Envelope Tracking system , 2011, 2011 IEEE MTT-S International Microwave Symposium.

[11]  J. Benedikt,et al.  Characterization of electrical memory effects for complex multi-tone excitations using broadband active baseband load-pull , 2012, 2012 7th European Microwave Integrated Circuit Conference.