Development of a segregated municipal solid waste gasification system for electrical power generation

[1]  Ajay Shah,et al.  Performance and emissions of a spark-ignited engine driven generator on biomass based syngas. , 2010, Bioresource technology.

[2]  R. K. Rajput.  Internal combustion engines : including air compressors and gas turbines and jet propulsion , 2007 .

[3]  Larry G. Felix,et al.  Optimization of thermally impregnated Ni–olivine catalysts for tar removal , 2009 .

[4]  Maria Laura Mastellone,et al.  Olivine as a tar removal catalyst during fluidized bed gasification of plastic waste , 2008 .

[5]  Maria Laura Mastellone,et al.  Fluidized bed gasification of waste-derived fuels. , 2010, Waste management.

[6]  J. T. Riley,et al.  A novel biomass air gasification process for producing tar-free higher heating value fuel gas , 2006 .

[7]  Emmanuel G. Koukios,et al.  Effect of leaching on the ash behavior of olive residue during fluidized bed gasification , 2002 .

[8]  Amado L. Maglinao,et al.  Predicting Fouling and Slagging Behavior of Dairy Manure (DM) and Cotton Gin Trash (CGT) During Thermal Conversion , 2010 .

[9]  Tony Bridgwater,et al.  THE PRODUCTION OF BIOFUELS BY THE THERMOCHEMICAL PROCESSING OF BIOMASS , 2004 .

[10]  F. Al-Mansour,et al.  An evaluation of biomass co-firing in Europe. , 2010 .

[11]  Thomas Malkow,et al.  Novel and innovative pyrolysis and gasification technologies for energy efficient and environmentally sound MSW disposal. , 2004, Waste management.

[12]  Nathanael J. Greene,et al.  GROWING ENERGY How Biofuels Can Help End America's Oil Dependence , 2004 .

[13]  M. Hupa,et al.  Sintering of ash during fluidized bed combustion , 1992 .

[14]  Dayou Liu,et al.  Novel experimental phenomena of fine-particle fluidized beds , 2007 .

[15]  Norman A. Anderson,et al.  Instrumentation for Process Measurement and Control , 1980 .

[16]  Philippe Mathieu,et al.  Performance analysis of a biomass gasifier , 2002 .

[17]  G. Sridhar,et al.  Producer Gas Engine - Proponent of Clean Energy Technology , 2007 .

[18]  Jerry D. Murphy,et al.  Technical, economic and environmental analysis of energy production from municipal solid waste , 2004 .

[19]  Chettiyappan Visvanathan,et al.  Recovery of plastic wastes from dumpsite as refuse-derived fuel and its utilization in small gasification system. , 2010, Bioresource technology.

[20]  Seth A. Lawson,et al.  Experimental and modeling study of hydrogen/syngas production and particulate emissions from a natural gas-fueled partial oxidation engine , 2006 .

[21]  Johan E. Hustad,et al.  Biomass combustion research and utilisation in IEA countries , 1995 .

[22]  P. P. Parikh,et al.  Development of a 15 kWe spark ignition producer gas engine and some investigations of its in-cylinder processes , 1994 .

[23]  B. Xiao,et al.  Hydrogen-rich gas production by steam gasification of municipal solid waste (MSW) using NiO supported on modified dolomite , 2012 .

[24]  John B. Heywood,et al.  Internal combustion engine fundamentals , 1988 .

[25]  Peter McKendry,et al.  Energy production from biomass (Part 1): Overview of biomass. , 2002, Bioresource technology.

[26]  N. Stanley‐Wood.  Bulk Powder Properties: Instrumentation and Techniques , 2009 .

[27]  Despina Vamvuka,et al.  Predicting the behaviour of ash from agricultural wastes during combustion , 2004 .

[28]  Larry L. Baxter,et al.  Alkali deposits found in biomass power plants: A preliminary investigation of their extent and nature. Volume 1 , 1995 .

[29]  Electo Eduardo Silva Lora,et al.  Syngas production in downdraft biomass gasifiers and its application using internal combustion engines , 2012 .

[30]  F. Pinto,et al.  Co-gasification study of biomass mixed with plastic wastes , 2002 .

[31]  Pradeep Bansal,et al.  Spark-ignition engine performance with ‘Powergas’ fuel (mixture of CO/H2): A comparison with gasoline and natural gas , 2006 .

[32]  F. W. Pittuck,et al.  Fundamentals of Motor Vehicle Technology , 1981 .

[33]  S. Dasappa,et al.  Operational experience on a grid connected 100 kWe biomass gasification power plant in Karnataka, India , 2011 .

[34]  Andrew Narvaez,et al.  Biomass gasification with air in an atmospheric bubbling fluidized bed. Effect of six operational variables on the quality of the produced raw gas , 1996 .

[35]  Klaus R. G. Hein,et al.  Slagging and fouling in biomass co-combustion , 2005 .

[36]  Norman S. Nise,et al.  Control Systems Engineering , 1991 .

[37]  Umberto Arena,et al.  Gasification: an alternative solution for waste treatment with energy recovery. , 2011, Waste management.

[38]  John W. Carson.  Hopper/Bin Design , 2009 .

[39]  Matti Hiltunen,et al.  Sintering mechanisms of FBC ashes , 1994 .

[40]  A. Gupta,et al.  Pyrolysis and gasification of food waste: Syngas characteristics and char gasification kinetics , 2010 .

[41]  Anil K. Rajvanshi,et al.  Biomass Gasification , 2005 .

[42]  K. Chiang,et al.  Application of response surface methodology in describing the thermal performances of a pin-fin heat sink , 2009 .

[43]  Mikko Hupa,et al.  The ash chemistry in fluidised bed gasification of biomass fuels. Part I: predicting the chemistry of melting ashes and ash–bed material interaction , 2001 .

[44]  Kj Krzysztof Ptasinski,et al.  Olivine as tar removal catalyst for biomass gasifiers: Catalyst characterization , 2005 .

[45]  Anssi Ahtikoski,et al.  Economic viability of utilizing biomass energy from young stands—The case of Finland , 2008 .

[46]  T. Bridgwater.  Biomass for energy , 2006 .

[47]  M. M. Roy,et al.  Performance and emission comparison of a supercharged dual-fuel engine fueled by producer gases with varying hydrogen content , 2009 .

[48]  S. Dasappa,et al.  Green Electricity - A Case Study of Grid Linked Independent Power Producer , 2007 .

[49]  S. Stanzl-tschegg.  Fracture Properties of Wood and Wood Composites , 2009 .

[50]  P. Paul,et al.  Biomass derived producer gas as a reciprocating engine fuel—an experimental analysis , 2001 .

[51]  A. Bridgwater.  The technical and economic feasibility of biomass gasification for power generation , 1995 .

[52]  C. Cormos.  Hydrogen and power co-generation based on coal and biomass/solid wastes co-gasification with carbon capture and storage , 2012 .

[53]  J. S. Mason,et al.  Bulk Solids Handling: An Introduction to the Practice and Technology , 2011 .

[54]  Amado L. Maglinao.  Instrumentation and Evaluation of a Pilot Scale Fluidized Bed Biomass Gasification System , 2009 .

[55]  P. Rao,et al.  Use of hydrogen in dual-fuel engines , 1982 .

[56]  P. Basu.  Combustion and gasification in fluidized beds , 2006 .

[57]  Ryan Michael Swanson,et al.  Techno-Economic Analysis of Biofuels Production Based on Gasification , 2010 .

[58]  Stefano Consonni,et al.  Waste gasification vs. conventional Waste-to-Energy: a comparative evaluation of two commercial technologies. , 2012, Waste management.

[59]  Brent R. Young,et al.  A Real-Time Approach to Process Control , 2000 .

[60]  Paul T. Williams,et al.  Pyrolysis-gasification of agriculture biomass wastes for hydrogen production , 2011 .

[61]  R. Warnecke,et al.  Gasification of biomass: comparison of fixed bed and fluidized bed gasifier , 2000 .

[62]  Toshio Shudo,et al.  COMBUSTION CHARACTERISTICS OF WASTE-PYROLYSIS GASES IN AN INTERNAL COMBUSTION ENGINE , 2003 .

[63]  A. J. Chandler,et al.  World terends in municipal solid waste management , 1996 .

[64]  A. W. Jenike,et al.  STORAGE AND FLOW OF SOLIDS :(REV. 1980. ) , 1980 .

[65]  M. Llorente,et al.  Comparing methods for predicting the sintering of biomass ash in combustion , 2005 .

[66]  Paul T. Williams,et al.  Hydrogen production from the pyrolysisgasification of waste tyres with a nickel/cerium catalyst , 2011 .

[67]  Maria Laura Mastellone,et al.  Fluidized Bed Pyrolysis of Plastic Wastes , 2006 .

[68]  S. C. Bhattacharya,et al.  Multi-stage reactor for thermal gasification of wood , 1994 .

[69]  E. Kakaras,et al.  Agglomeration in fluidised bed gasification of biomass , 2008 .

[70]  P. Abdul Salam,et al.  Estimation of higher heating value of biomass from proximate analysis: A new approach , 2012 .

[71]  T. Takarada,et al.  Two-stage steam gasification of waste biomass in fluidized bed at low temperature: parametric investigations and performance optimization. , 2011, Bioresource technology.

[72]  G. Annadurai,et al.  Use of Box-Behnken design of experiments for the adsorption of verofix red using biopolymer , 1998 .

[73]  R. Jorapur,et al.  98/00444 Sugarcane leaf-bagasse gasifiers for industrial heating applications , 1997 .

[74]  Marek Pronobis,et al.  Evaluation of the influence of biomass co-combustion on boiler furnace slagging by means of fusibility correlations , 2005 .

[75]  C Sagüés,et al.  Automatic control of biomass gasifiers using fuzzy inference systems. , 2007, Bioresource technology.

[76]  A. A. Abdel-Rahman,et al.  On the emissions from internal-combustion engines: a review , 1998 .

[77]  Jiri Marek,et al.  Automotive sensors , 2003, SPIE MOEMS-MEMS.

[78]  Guo-Qiang Zhang,et al.  Trigeneration: A new way for landfill gas utilization and its feasibility in Hong Kong , 2008 .

[79]  Steffen Heidenreich,et al.  Gas cleaning, gas conditioning and tar abatement by means of a catalytic filter candle in a biomass fluidized-bed gasifier. , 2010, Bioresource technology.

[80]  A. B. Fadhil.  Optimization of Transesterification Parameters of Melon Seed Oil , 2013 .

[81]  B. Jenkins,et al.  Combustion properties of biomass , 1998 .

[82]  B. Coda,et al.  Entrained flow gasification of biomass Ash behaviour, feeding issues, system analyses , 2004 .