Parameterization of Surface Roughness Based on ICESat/GLAS Full Waveforms: A Case Study on the Tibetan Plateau

Glaciers in the Tibetan mountains are expected to be sensitive to turbulent sensible and latent heat fluxes. One of the most significant factors of the energy exchange between the atmospheric boundary layer and the glacier is the roughness of the glacier surface. However, methods to parameterize this roughness for glacier surfaces in remote regions are not well known. In this paper, the authors use the data acquired by Ice, Cloud, and Land Elevation Satellite (ICESat)/Geoscience Laser Altimeter System (GLAS) laser altimetry from February 2003 to November 2004 along several tracks over glaciers of the Nyainqentanglha range in central Tibet. The authors make a study of the waveforms measured by the ICESat/GLAS laser system over mountainous and glacial areas. The surface characteristics are evaluated within laser footprints over the glacier outlines based on the glaciological inventory of the Tibetan Plateau constructed by the Cold and Arid Regions Environmental and Engineering Research Institute (CAREERI), Chinese Academy of Sciences. For this purpose, the authors extract waveform parameters: the waveform width, the number of modes, and the RMS width of the waveform. These parameters are compared with surface slope and roughness obtained from the Advanced Spaceborne Thermal Emission and Reflection Radar (ASTER) Global Digital Elevation Model (GDEM). Through this analysis, the impact of morphology on the returned laser waveform is shown for the Nyainq^entanglha range. The roughness and the slope of the surface can be quite significant and may contribute from several meters to tens of meters to the pulse extent. The waveform analysis results indicate that the received waveforms are capable representations of surface relief within the GLAS footprints.

[1]  T. Yao,et al.  Recent Glacial Retreat and Its Impact on Hydrological Processes on the Tibetan Plateau, China, and Surrounding Regions , 2007 .

[2]  J. Garratt.  The Atmospheric Boundary Layer , 1992 .

[3]  S. Arya,et al.  A drag partition theory for determining the large-scale roughness parameter and wind stress on the Arctic pack ice , 1975 .

[4]  J. Abshire,et al.  Geoscience Laser Altimeter System (GLAS) on the ICESat Mission: On‐orbit measurement performance , 2005 .

[5]  H. Zwally.  ICESat's Laser Measurements of Polar Ice and Atmospheres , 2003 .

[6]  Jerry C. Ritchie,et al.  Estimation of effective aerodynamic roughness of Walnut Gulch watershed with laser altimeter measurements , 1994 .

[7]  Yafeng Shi,et al.  Estimation on the response of glaciers in China to the global warming in the 21st century , 2000 .

[8]  P. Burrough,et al.  Principles of geographical information systems , 1998 .

[9]  Xiaoli Sun,et al.  ICESat measurement of Greenland ice sheet surface slope and roughness , 2005, Annals of Glaciology.

[10]  Chester S. Gardner,et al.  Ranging performance of satellite laser altimeters , 1992, IEEE Trans. Geosci. Remote. Sens..

[11]  Yushin Ahn,et al.  Surface roughness over the northern half of the Greenland Ice Sheet from airborne laser altimetry , 2009 .

[12]  E. L. Andreas.  Parameterizing Scalar Transfer over Snow and Ice: A Review , 2002 .

[13]  Norbert Pfeifer,et al.  ICESat Full-Waveform Altimetry Compared to Airborne Laser Scanning Altimetry Over The Netherlands , 2009, IEEE Transactions on Geoscience and Remote Sensing.

[14]  W. F. Budd,et al.  An Analysis of the Relation Between the Surface and Bedrock Profiles of Ice Caps , 1971, Journal of Glaciology.

[15]  Yasushi Yamaguchi,et al.  Overview of Advanced Spaceborne Thermal Emission and Reflection Radiometer (ASTER) , 1998, IEEE Trans. Geosci. Remote. Sens..

[16]  J. Oerlemans.  Analysis of a 3 year meteorological record from the ablation zone of Morteratschgletscher, Switzerland: energy and mass balance , 2000, Journal of Glaciology.

[17]  Wang Zongtai,et al.  Characteristics of the distribution of glaciers in China , 1992, Annals of Glaciology.

[18]  A. Goetz,et al.  Estimates of forest canopy fuel attributes using hyperspectral data , 2006 .

[19]  William P. Kustas,et al.  An Evaluation of Two Models for Estimation of the Roughness Height for Heat Transfer between the Land Surface and the Atmosphere , 2001 .

[20]  J. Monteith,et al.  Boundary Layer Climates. , 1979 .

[21]  H. Zwally,et al.  Overview of ICESat's Laser Measurements of Polar Ice, Atmosphere, Ocean, and Land , 2002 .

[22]  J. Oerlemans,et al.  Sensitivity of Glaciers and Small Ice Caps to Greenhouse Warming , 1992, Science.

[23]  Ron Kwok,et al.  ICESat over arctic sea ice : Interpretation of altimetric and reflectivity profiles , 2006 .

[24]  S. Arya.  Suggested Revisions to Certain Boundary Layer Parameterization Schemes Used in Atmospheric Circulation Models , 1977 .

[25]  E. Kang,et al.  The Glacier Inventory of China , 2009, Annals of Glaciology.

[26]  Xiaoli Sun,et al.  Geoscience laser altimeter system (GLAS) on the ICESat mission: pre-launch and on-orbit measurement performance , 2003, IGARSS 2003. 2003 IEEE International Geoscience and Remote Sensing Symposium. Proceedings (IEEE Cat. No.03CH37477).

[27]  Asgeir Sorteberg,et al.  Modelled mass balance of Xibu glacier, Tibetan Plateau: sensitivity to climate change , 2010, Journal of Glaciology.

[28]  A. Obukhov,et al.  Turbulence in an atmosphere with a non-uniform temperature , 1971 .

[29]  Xiaoli Sun,et al.  Geoscience laser altimeter system (GLAS) for the ICESat mission-pre-launch performance , 2003, Conference on Lasers and Electro-Optics, 2003. CLEO '03..

[30]  C. Gardner,et al.  Target signatures for laser altimeters: an analysis. , 1982, Applied optics.

[31]  S. T. Buckland,et al.  An Introduction to the Bootstrap. , 1994 .

[32]  B. Denby,et al.  The use of bulk and profile methods for determining surface heat fluxes in the presence of glacier winds , 2000, Journal of Glaciology.

[33]  W. Cohen,et al.  Estimates of forest canopy height and aboveground biomass using ICESat , 2005 .

[34]  M. Sharp,et al.  Measurement and parameterization of aerodynamic roughness length variations at Haut Glacier d'Arolla, Switzerland , 2006 .

[35]  Hiroyuki Fujisada,et al.  ASTER DEM performance , 2005, IEEE Transactions on Geoscience and Remote Sensing.

[36]  D. Harding,et al.  ICESat waveform measurements of within‐footprint topographic relief and vegetation vertical structure , 2005 .

[37]  Edgar L. Andreas,et al.  A theory for the scalar roughness and the scalar transfer coefficients over snow and sea ice , 1987 .

[38]  M. Kaku,et al.  DEM Generation with ASTER Stereo Data , 1995 .

[39]  B. Denby,et al.  Derivation of Turbulent Flux Profiles and Roughness Lengths from Katabatic Flow Dynamics , 2000 .

[40]  D. S. Munro,et al.  Surface Roughness and Bulk Heat Transfer on a Glacier: Comparison with Eddy Correlation , 1989, Journal of Glaciology.

[41]  M. Menenti,et al.  Effective aerodynamic roughness estimated from airborne laser altimeter measurements of surface features , 2003 .

[42]  R. Hock,et al.  Some aspects of energy balance and ablation of Storglaciaren, northern Sweden , 1996 .

[43]  Neil S. Arnold,et al.  Modelling seasonal and spatial variations in the surface energy balance of Haut Glacier d’Arolla, Switzerland , 2000, Annals of Glaciology.

[44]  Giuseppe Conti,et al.  Geographical Information , 1921 .

[45]  S. Arya.  Contribution of form drag on pressure ridges to the air stress on Arctic ice , 1973 .

[46]  Bruno Sportisse,et al.  Atmospheric Boundary Layer , 2010 .