Accelerated Kinetics of Hydrogen Oxidation Reaction on the Ni Anode Coupled with Bazr0.9y0.1o3-Δ Proton-Conducting Ceramic Electrolyte Via Tuning the Electrolyte Surface Chemistry

[1]  Dimitrios K. Pappas,et al.  Single-step hydrogen production from NH3, CH4, and biogas in stacked proton ceramic reactors , 2022, Science.

[2]  D. Osinkin,et al.  H/D isotopic exchange and electrochemical kinetics of hydrogen oxidation on Ni-cermets with oxygen-ionic and protonic electrolytes , 2022, Journal of Power Sources.

[3]  Wenge Yang,et al.  Optimizing the Proton Conductivity with the Isokinetic Temperature in Perovskite‐Type Proton Conductors According to Meyer–Neldel Rule , 2021, Advanced Energy Materials.

[4]  Nan Wang,et al.  The sustainability of regional decarbonization through the global value chain analytical framework: A case study of Germany , 2021 .

[5]  Yushan Yan,et al.  A green hydrogen economy for a renewable energy society , 2021 .

[6]  N. Brandon,et al.  Designing the next generation of proton-exchange membrane fuel cells , 2021, Nature.

[7]  Ze Zhang,et al.  Fabrication and performance of anode-supported proton conducting solid oxide fuel cells based on BaZr0.1Ce0.7Y0.1Yb0.1O3-δ electrolyte by multi-layer aqueous-based co-tape casting , 2021 .

[8]  Y. Hu,et al.  Progress in proton‐conducting oxides as electrolytes for low‐temperature solid oxide fuel cells: From materials to devices , 2021, Energy Science & Engineering.

[9]  Shuangbin Li,et al.  Non-stoichiometry, structure and properties of proton-conducting perovskite oxides , 2021, Solid State Ionics.

[10]  M. Bazilian,et al.  Progress towards a circular economy in materials to decarbonize electricity and mobility , 2021 .

[11]  Xinxin Wang,et al.  New two-layer Ruddlesden—Popper cathode materials for protonic ceramics fuel cells , 2021, Journal of Advanced Ceramics.

[12]  Xin Liu,et al.  Yttrium‐Doped Barium Zirconate‐Cerate Solid Solution as Proton Conducting Electrolyte: Why Higher Cerium Concentration Leads to Better Performance for Fuel Cells and Electrolysis Cells , 2021, Advanced Energy Materials.

[13]  Yu Chen,et al.  An Efficient and Durable Anode for Ammonia Protonic Ceramic Fuel Cells , 2021, Energy & Environmental Science.

[14]  Zongping Shao,et al.  Electrochemistry and energy conversion features of protonic ceramic cells with mixed ionic-electronic electrolytes , 2021, Energy & Environmental Science.

[15]  T. Morawietz,et al.  A high-performance, durable and low-cost proton exchange membrane electrolyser with stainless steel components , 2021, Energy & Environmental Science.

[16]  Dongchu Chen,et al.  Space charge layer effect at the platinum anode/BaZr0.9Y0.1O3−δ electrolyte interface in proton ceramic fuel cells , 2020 .

[17]  L. Hultman,et al.  X-ray photoelectron spectroscopy: Towards reliable binding energy referencing , 2020, Progress in Materials Science.

[18]  K. Ayers,et al.  A non-precious metal hydrogen catalyst in a commercial polymer electrolyte membrane electrolyser , 2019, Nature Nanotechnology.

[19]  J. M. Serra,et al.  Mixed proton and electron conducting double perovskite anodes for stable and efficient tubular proton ceramic electrolysers , 2019, Nature Materials.

[20]  Dongchu Chen,et al.  Densification and electrical conducting behavior of BaZr0.9Y0.1O3-δ proton conducting ceramics with NiO additive , 2019, Journal of Alloys and Compounds.

[21]  N. Sullivan,et al.  Highly efficient reversible protonic ceramic electrochemical cells for power generation and fuel production , 2019, Nature Energy.

[22]  N. Sullivan,et al.  Highly durable, coking and sulfur tolerant, fuel-flexible protonic ceramic fuel cells , 2018, Nature.

[23]  B. Koo,et al.  Enhanced oxygen exchange of perovskite oxide surfaces through strain-driven chemical stabilization , 2018 .

[24]  J. M. Serra,et al.  Thermo-electrochemical production of compressed hydrogen from methane with near-zero energy loss , 2017 .

[25]  T. Norby,et al.  Comparison of Cu and Pt point-contact electrodes on proton conducting BaZr0.7Ce0.2Y0.1O3−δ , 2017 .

[26]  Kazunari Sasaki,et al.  Public perception on hydrogen infrastructure in Japan: Influence of rollout of commercial fuel cell vehicles , 2017 .

[27]  H. J. Choi,et al.  Demonstrating the potential of yttrium-doped barium zirconate electrolyte for high-performance fuel cells , 2017, Nature Communications.

[28]  Bilge Yildiz,et al.  Improved chemical and electrochemical stability of perovskite oxides with less reducible cations at the surface. , 2016, Nature materials.

[29]  J. M. Serra,et al.  Direct conversion of methane to aromatics in a catalytic co-ionic membrane reactor , 2016, Science.

[30]  S. E. Hosseini,et al.  Hydrogen production from renewable and sustainable energy resources: Promising green energy carrier for clean development , 2016 .

[31]  S. Barnett,et al.  Mechanisms of Performance Degradation of (La,Sr)(Co,Fe)O3-δ Solid Oxide Fuel Cell Cathodes , 2016 .

[32]  Joon-Hyung Lee,et al.  Effect of Ba Nonstoichiometry in Bax(Zr0.8Y0.2)O3−δ on Population of 5‐Coordinated Y , 2014 .

[33]  T. Ishihara,et al.  Surface composition of perovskite-type materials studied by Low Energy Ion Scattering (LEIS) , 2014 .

[34]  A. Savara.  Standard States for Adsorption on Solid Surfaces: 2D Gases, Surface Liquids, and Langmuir Adsorbates , 2013 .

[35]  S. McIntosh,et al.  On the H2/D2 isotopic exchange rate of proton conducting barium cerates and zirconates , 2013 .

[36]  Bilge Yildiz,et al.  Cation size mismatch and charge interactions drive dopant segregation at the surfaces of manganite perovskites. , 2013, Journal of the American Chemical Society.

[37]  Bernd Müller,et al.  Fuel cell electric vehicles and hydrogen infrastructure: status 2012 , 2012 .

[38]  E. Traversa,et al.  Sinteractive anodic powders improve densification and electrochemical properties of BaZr0.8Y0.2O3−δ electrolyte films for anode-supported solid oxide fuel cells , 2011 .

[39]  S. Haile,et al.  Cation non-stoichiometry in yttrium-doped barium zirconate: phase behavior, microstructure, and proton conductivity , 2010 .

[40]  Ryan O'Hayre,et al.  Solid-state reactive sintering mechanism for large-grained yttrium-doped barium zirconate proton conducting ceramics , 2010 .

[41]  Ryan O'Hayre,et al.  Cost-effective solid-state reactive sintering method for high conductivity proton conducting yttrium-doped barium zirconium ceramics , 2010 .

[42]  S. Haile,et al.  High Total Proton Conductivity in Large-Grained Yttrium-Doped Barium Zirconate , 2009 .

[43]  S. Haile,et al.  Atomistic Study of Doped BaCeO3: Dopant Site-Selectivity and Cation Nonstoichiometry , 2005 .

[44]  N. Bonanos,et al.  Investigation of hydrogen oxidation reaction on a metal/perovskite proton conductor interface by impedance spectroscopy , 2001 .

[45]  Mogens Bjerg Mogensen,et al.  Oxidation of hydrogen on Ni/yttria-stabilized zirconia cermet anodes , 1997 .

[46]  T. Norby.  EMF method determination of conductivity contributions from protons and other foreign ions in oxides , 1988 .

[47]  M. Sluyters-Rehbach,et al.  ELECTRODE KINETICS AND DOUBLE LAYER STRUCTURE , 1969 .