Propagation of sub-surface cracks in railway wheels for wear-induced conformal contacts

The ability to predict the criticality of internal cracks in railway wheels requires accurate knowledge of stress intensity factors KI, KII, KIII under contact loads. These factors depend both on the total load acting on the wheel and on how the load is transmitted through the wheel/rail interface, that is to say, they depends on the pressure distribution between wheel and rail. However, till today the solutions commonly used consider a theoretical (Hertzian) pressure distribution, even though the real contact patch may be far different for most of the lifespan of the wheel due to wear or to the dynamic conditions. In this paper an approach is developed with the aim of solving the case of an internally cracked wheel subjected to an arbitrary contact patch and pressure distribution. In particular, attention is focused on the case of hollow wear, which makes it possible to obtain very conformal contacts. The results are discussed and compared with the analytical solutions that consider Hertzian pressure distributions with the same total load.

[1]  Mario Guagliano,et al.  Experimental and numerical analysis of sub-surface cracks in railway wheels , 2005 .

[2]  Mario Guagliano,et al.  A Hybrid Approach for Subsurface Crack Analyses in Railway Wheels under Rolling Contact Loads , 2003 .

[3]  M. Kaneta,et al.  Growth Mechanism of Subsurface Crack Due to Hertzian Contact , 1986 .

[4]  Leon M Keer,et al.  Rough Contact Between Elastically and Geometrically Identical Curved Bodies , 1982 .

[5]  Roger Lundén.  Cracks in Railway Wheels under Rolling Contact Load , 1992 .

[6]  Massimiliano Pau,et al.  An experimental–numerical approach for the analysis of internally cracked railway wheels , 2008 .

[7]  Leon M Keer,et al.  SUBSURFACE AND SURFACE CRACKING DUE TO HERTZIAN CONTACT. , 1982 .

[8]  R Lewis,et al.  An ultrasonic approach for contact stress mapping in machine joints and concentrated contacts , 2004 .

[9]  S.-S. Cho,et al.  Finite element analysis of subsurface crack propagation in a half-space due to a moving asperity contact , 1997 .

[10]  L. E. Goodman,et al.  The Stress Field Created by a Circular Sliding Contact , 1966 .

[11]  G. T. Hahn,et al.  Finite element modelling of subsurface mode II cracks under contact loads , 1989 .

[12]  D. Tabor,et al.  An utrasonic study of the area of contact between stationary and sliding surfaces , 1971, Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences.

[13]  Russell Walker,et al.  The effect of hollow-worn wheels on vehicle stability in straight track , 2005 .

[14]  Rob Dwyer-Joyce,et al.  The measurement of contact pressure in machine elements using ultrasound , 2002 .

[15]  Francesco Aymerich,et al.  Ultrasonic measurements of nominal contact area and contact pressure in a wheel-rail system , 2000 .

[16]  Francesco Aymerich,et al.  Distribution of contact pressure in wheel-rail contact area , 2000 .

[17]  Massimiliano Pau,et al.  Analysis of internal cracks in railway wheels under experimentally determined pressure distributions , 2007 .

[18]  Rob Dwyer-Joyce,et al.  An approach for contact stress mapping in joints and concentrated contacts , 2004 .