Smoothing Techniques to Improve Flow Solution Convergence for Modeling Surface Erosion or Deposition in Two-Phase Flows

[1]  J. Bons,et al.  The Effect of Gas and Surface Temperature on Cold-Side and Hot-Side Turbine Deposition , 2022, Journal of turbomachinery.

[2]  Xin Yang,et al.  CFD modelling of biomass ash deposition under multiple operation conditions using a 2D mass-conserving dynamic mesh approach , 2022, Fuel.

[3]  J. Bons,et al.  Assessment of stochastic models for predicting particle transport and deposition in turbulent pipe flows , 2022, Journal of Aerosol Science.

[4]  J. Bons,et al.  Enhancing Turbine Deposition Prediction Capability With Conjugate Mesh Morphing , 2021, Volume 2B: Turbomachinery — Axial Flow Turbine Aerodynamics; Deposition, Erosion, Fouling, and Icing.

[5]  Hao Zhou,et al.  Numerical simulation of ash deposition behavior with a novel erosion model using dynamic mesh , 2021 .

[6]  Eduardo Suárez,et al.  Development of a Computational Fluid Dynamics Model for Predicting Fouling Process Using Dynamic Mesh Model , 2020, Heat Transfer Engineering.

[7]  J. Bons,et al.  The Effect of Elevated Temperatures on Airborne Particle Deposition and Rebounds , 2020 .

[8]  S. Khanna,et al.  Prediction of sand erosion in CFD with dynamically deforming pipe geometry and implementing proper treatment of turbulence dispersion in particle tracking , 2019, Wear.

[9]  J. Bons,et al.  Modeling Deposition in Turbine Cooling Passages With Temperature-Dependent Adhesion and Mesh Morphing , 2018, Journal of Engineering for Gas Turbines and Power.

[10]  J. Bons,et al.  An Improved Particle Impact Model by Accounting for Rate of Strain and Stochastic Rebound , 2018, Volume 2D: Turbomachinery.

[11]  Alejandro López,et al.  CFD study of fluid flow changes with erosion , 2018, Comput. Phys. Commun..

[12]  Peter R. Forsyth,et al.  Development and Applications of a Coupled Particle Deposition - Dynamic Mesh Morphing Approach for the Numerical Simulation of Gas Turbine Flows , 2017 .

[13]  Timo Hyppänen,et al.  Fouling growth modeling of kraft recovery boiler fume ash deposits with dynamic meshes and a mechanistic sticking approach , 2016 .

[14]  J. Bons,et al.  A SIMPLE PHYSICS-BASED MODEL FOR PARTICLE REBOUND AND DEPOSITION IN TURBOMACHINERY , 2016 .

[15]  Richard K. Beatson,et al.  Reconstruction and representation of 3D objects with radial basis functions , 2001, SIGGRAPH.

[16]  D. Shepard.  A two-dimensional interpolation function for irregularly-spaced data , 1968, ACM National Conference.

[17]  Wenming Yang,et al.  Simulating growth of ash deposit in boiler heat exchanger tube based on CFD dynamic mesh technique , 2020 .