1.5% root-mean-square flat-intensity laser beam formed using a binary-amplitude spatial light modulator.

We demonstrate a digital micromirror device (DMD)-based optical system that converts a spatially noisy quasi-Gaussian to an eighth-order super-Lorentzian flat-top beam. We use an error-diffusion algorithm to design the binary pattern for the Texas Instruments DLP device. Following the DMD, a telescope with a pinhole low-pass filters the beam and scales it to the desired sized image. Experimental measurements show a 1% root-mean-square (RMS) flatness over a diameter of 0.28 mm in the center of the flat-top beam and better than 1.5% RMS flatness over its entire 1.43 mm diameter. The power conversion efficiency is 37%. We develop an alignment technique to ensure that the DMD pattern is correctly positioned on the incident beam. An interferometric measurement of the DMD surface flatness shows that phase uniformity is maintained in the output beam. Our approach is highly flexible and is able to produce not only flat-top beams with different parameters, but also any slowly varying target beam shape. It can be used to generate the homogeneous optical lattice required for Bose-Einstein condensate cold atom experiments.

[1]  Matthew Pasienski,et al.  A high-accuracy algorithm for designing arbitrary holographic atom traps. , 2007, Optics express.

[2]  J. Ignacio Cirac,et al.  Simulation of quantum dynamics with quantum optical systems , 2003, Quantum Inf. Comput..

[3]  C. J. Kastner,et al.  Beam profile shaping for laser radars that use detector arrays. , 1982, Applied optics.

[4]  Fred M. Dickey,et al.  Gaussian laser beam profile shaping , 1996 .

[5]  Liren Liu,et al.  Superresolution laser beam shaping. , 2004, Applied optics.

[6]  Eric Audouard,et al.  Programmable focal spot shaping of amplified femtosecond laser pulses. , 2005, Optics letters.

[7]  J. Stoffel,et al.  A Survey of Electronic Techniques for Pictorial Image Reproduction , 1981, IEEE Trans. Commun..

[8]  Nicolas Passilly,et al.  Beam-shaping longitudinal range of a binary diffractive optical element. , 2006, Applied optics.

[9]  Carl C. Aleksoff,et al.  Holographic conversion of a Gaussian beam to a near-field uniform beam , 1991 .

[10]  V P Karpenko,et al.  Serrated-aperture apodizers for high-energy laser systems. , 1994, Applied optics.

[11]  C. M. Jefferson,et al.  Design and performance of a refractive optical system that converts a Gaussian to a flattop beam. , 2000, Applied optics.

[12]  M. Takamoto,et al.  An optical lattice clock , 2005, Nature.

[13]  Christophe Dorrer,et al.  Design and analysis of binary beam shapers using error diffusion , 2007 .

[14]  K. A. Ameur,et al.  Optimization of the Gaussian beam flattening using a phase-plate , 1997 .

[15]  J Cordingley,et al.  Application of a binary diffractive optic for beam shaping in semiconductor processing by lasers. , 1993, Applied optics.

[16]  Louis A. Romero,et al.  Lossless laser beam shaping , 1996 .

[17]  C. Michel,et al.  Generation of a flat-top laser beam for gravitational wave detectors by means of a nonspherical Fabry-Perot resonator. , 2007, Applied optics.