Investigating effects of BCC and FCC arrangements on flow and heat transfer characteristics in pebbles through CFD methodology

Abstract A high temperature gas cooled reactor (HTGR) would be one of the possible energy generation sources due to its advantages of inherently safety performance and higher conversion efficiency, etc. However, safety is the most important issue for its commercialization in energy industry. It is very crucial for safety design and operation of an HTGR to investigate its thermal–hydraulic characteristics. In this article, a computational fluid dynamics (CFD) methodology is proposed to investigate effects of different arrangements on these characteristics for an HTGR with a pebble bed (PB) core. Two kinds of arrangement: body-centered cubic (BCC) and face-centered cubic (FCC) are studies herein. Based on the simulation results, higher heat transfer capability and lower pebble temperature are predicted in the pebbles with the FCC-arrangement. The thermally fully-developed flow condition may be reached, which is shown in the result that the predicted average Nussel (Nu) number decreases from the 1st layer and reaches to an asymptotic value as the gas passes through the 6th layer of pebbles. This entrance effect reveals that the system codes using the correlations developed from the fully-developed flow condition can be appropriately applied in the entire PBR core. In addition, the present predicted dependence of Nu number on the inlet Reynolds (Re) number shows good agreement with that obtained from the well-known KTA. Measured data of Nu number versus Re number are also used to validate the CFD model.

[1]  W. P. Jones,et al.  Closure of the Reynolds stress and scalar flux equations , 1988 .

[2]  Kwang-Yong Kim,et al.  Numerical treatment of pebble contact in the flow and heat transfer analysis of a pebble bed reactor core , 2007 .

[3]  Andrew C. Kadak,et al.  Individual pebble temperature peaking factor due to local pebble arrangement in a pebble bed reactor core , 2011 .

[4]  CFD simulation of particle deposition on an array of spheres using an Euler/Lagrange approach , 2011 .

[5]  Eduard Egusquiza,et al.  Performance of stress-transport models in the prediction of particle-to-fluid heat transfer in packed beds , 2007 .

[6]  Anthony G. Dixon,et al.  Systematic mesh development for 3D CFD simulation of fixed beds: Single sphere study , 2011, Comput. Chem. Eng..

[7]  Günter Lohnert,et al.  The impact of design on the decay heat removal capabilities of a modular pebble bed HTR , 2006 .

[8]  Min Zeng,et al.  Experimental analysis of forced convective heat transfer in novel structured packed beds of particles , 2012 .

[9]  Henri Fenech,et al.  Heat transfer and fluid flow in nuclear systems , 1981 .

[10]  W. Bernnat,et al.  Models for reactor physics calculations for HTR pebble bed modular reactors , 2003 .

[11]  D. Spalding,et al.  A calculation procedure for heat, mass and momentum transfer in three-dimensional parabolic flows , 1972 .

[12]  Yassin A. Hassan,et al.  Large eddy simulation in pebble bed gas cooled core reactors , 2008 .

[13]  J. Lamarsh.  Introduction to Nuclear Engineering , 1975 .

[14]  J. J. Van Der Merwe,et al.  HTR fuel design, qualification and analyses at PBMR , 2006 .

[15]  P. G. Rousseau,et al.  A review of correlations to model the packing structure and effective thermal conductivity in packed beds of mono-sized spherical particles , 2010 .

[16]  Yassin A. Hassan,et al.  CFD Simulation of a Coolant Flow and a Heat Transfer in a Pebble Bed Reactor , 2008 .

[17]  M. Q. Huda,et al.  Development and testing of analytical models for the pebble bed type HTRs , 2008 .

[18]  Chung-Yun Wu,et al.  Investigating the advantages and disadvantages of realistic approach and porous approach for closely packed pebbles in CFD simulation , 2010 .

[19]  Calculation of turbulent heat flux distributions in a square duct with one roughened wall by means of algebraic heat flux models , 2002 .

[20]  Lei Shi,et al.  Thermal hydraulic calculation of the HTR-10 for the initial and equilibrium core , 2002 .