Experimental and computational investigations of hypersonic flow about compression ramps

Comprehensive results of a joint experimental and computational study of the two-dimensional flow field over flat plate/compression ramp configurations at Mach 14 are presented. These geometries are aimed to simulate, in a simplified manner, the region around deflected control surfaces of hypersonic re-entry vehicles. The test cases considered cover a range of realistic flow conditions with Reynolds numbers to the hinge line varying between 4.5×10 5 and 2.6×10 6 (with a reference length taken as the distance between the leading edge and the hinge line) and a wall-to-total-temperature ratio of 0.12. The combination of flow and geometric parameters gives rise to fully laminar strong shock wave/boundary layer interactions with extensive separation, and transitional interactions with transition occurring near the reattachment point. A fully turbulent interaction is also considered which, however, was only approximately achieved in the experiments by means of excessive tripping of the oncoming hypersonic laminar boundary layer. Emphasis has been placed upon the quality and level of confidence of both experiments and computations, including a discussion on the laminar-turbulent transition process and the associated striation phenomenon. The favourable comparison between the experimental and computational results has provided the grounds for an enhanced understanding of the relevant flow processes and their modelling. Particularly in relation to transitional shock wave/boundary layer interactions, where laminar-turbulent transition is promoted by the adverse pressure gradient and flow concavity in the reattachment region, a method is proposed to compute extreme adverse effects in the interaction region avoiding such inhibiting requirements as transition modelling or turbulence modelling over separated regions

[1]  T. Barber,et al.  Analysis of complex hypersonic flows with strong viscous/inviscid interaction , 1987 .

[2]  Unmeel B. Mehta.  Computational requirements for hypersonic flight performance estimates , 1990 .

[3]  T. V. Jones,et al.  Heat-transfer measurements in short-duration hypersonic facilities , 1973 .

[4]  W. L. Hankey,et al.  Two-Dimensional Shock Wave-Boundary Layer Interactions in High Speed Flows, , 1975 .

[5]  M. Holden.  Boundary-layer displacement and leading edge bluntness effects on attached and separated laminar boundary layers in a compression corner. I - Theoretical study , 1968 .

[6]  J. Green.  Interactions between shock waves and turbulent boundary layers , 1970 .

[7]  K. Stewartson,et al.  On the interaction between shock waves and boundary layers , 1951, Mathematical Proceedings of the Cambridge Philosophical Society.

[8]  Jerzy M. Floryan,et al.  On the görtler instability of boundary layers , 1991 .

[9]  H. W. Emmons,et al.  The Laminar-Turbulent Transition in a Boundary Layer-Part I , 1951 .

[10]  G. Messing,et al.  YBa2Cu3O7−x Superconductor powder synthesis by spray pyrolysis of organic acid solutions , 1991 .

[11]  Gary S. Settles,et al.  Reynolds Number Effects on Shock-Wave Turbulent Boundary-Layer Interactions , 1977 .

[12]  Gary S. Settles,et al.  Detailed Study of Attached and Separated Compression Corner Flowfields in High Reynolds Number Supersonic Flow , 1979 .

[13]  E. Reshotko,et al.  Shock-wave boundary layer interactions , 1986 .

[14]  Roddam Narasimha,et al.  Some properties of boundary layer flow during the transition from laminar to turbulent motion , 1958, Journal of Fluid Mechanics.

[15]  R. W. MacCormack,et al.  Numerical Solutions of Supersonic and Hypersonic Laminar Compression Corner Flows , 1976 .

[16]  D. M. Bushnell,et al.  Correlation of peak heating for reattachment of separated flows. , 1968 .

[17]  Werner Haase,et al.  Determination of length scales in algebraic turbulence models for Navier-Stokes methods , 1989 .