An experimental study of syn-gas production via microwave plasma reforming of methane, iso-octane and gasoline

A newly developed microwave plasma system for fuel reforming was tested for three different hydrocarbon fuels. The microwave plasma system was powered by a low cost commercial magnetron and power supply. The microwave power was delivered to the nozzle from the magnetron via a coaxial cable, which offers tremendous flexibility for system design and applications. A non-premixed configuration was achieved by delivering a separate stream of fuel to the plasma plume, which is composed of diluted oxygen only. The feasibility of syn-gas production capability of the microwave plasma system was demonstrated and the reforming characteristics of methane, iso-octane and gasoline were compared. The effects of input power, injected fuel amount, total flow rate and O/C ratio were evaluated. The production rates of both hydrogen and carbon monoxide were proportional to the input power and the inverse of the total flow rate. As a result, the maximum efficiency of 3.12% was obtained with iso-octane for power consumption of 28.8W, O/C ratio of 1, and 0.1g/min of fuel supply. Liquid fuels produced more syn-gas and showed better efficiency than methane for the same input powers and O/C ratios.

[1]  J. Mizeraczyk,et al.  Production of hydrogen via methane reforming using atmospheric pressure microwave plasma , 2008 .

[2]  Michel Moisan,et al.  An atmospheric pressure waveguide-fed microwave plasma torch: the TIA design , 1994 .

[3]  Gao Qing Lu,et al.  CO2 reforming of methane on Ni catalysts: Effects of the support phase and preparation technique , 1998 .

[4]  P. Fauchais,et al.  Thermal plasmas , 1997 .

[5]  Z. Zakrzewski,et al.  Waveguide-based single and multiple nozzle plasma torches: the TIAGO concept , 2001 .

[6]  M. Krumpelt,et al.  Hydrogen from hydrocarbon fuels for fuel cells , 2001 .

[7]  Hidetoshi Sekiguchi,et al.  Steam plasma reforming using microwave discharge , 2003 .

[8]  Shengguang Wang,et al.  A detailed mechanism of thermal CO2 reforming of CH4 , 2004 .

[9]  Keith D. King,et al.  Reforming of CH4 by partial oxidation: thermodynamic and kinetic analyses , 2001 .

[10]  Y. C. Kim,et al.  Oxidative coupling of methane with microwave and RF plasma catalytic reaction over transitional metals loaded on ZSM-5 , 2002 .

[11]  B. A. Wofford,et al.  Innovative Surface Wave Plasma Reactor Technique for PFC Abatement , 1998 .

[12]  A. Mizuno,et al.  Reforming of heavy oil using nonthermal plasma , 2001 .

[13]  A. Basile,et al.  An experimental study of multilayered composite palladium membrane reactors for partial oxidation of methane to syngas , 2001 .

[14]  S. C. Kim,et al.  Production of hydrogen by partial oxidation with thermal plasma , 2008 .

[15]  W. Maier,et al.  CO2-Reforming of Methane on Supported Rh and Ir Catalysts , 1996 .

[16]  J. Mathiak,et al.  Dynamics of H2 production by steam reforming , 2004 .

[17]  D. Rentsch,et al.  Gasoline composition determined by 1H NMR spectroscopy , 2004 .

[18]  Young Nam Chun,et al.  Characteristics of methane reforming using gliding arc reactor , 2009 .

[19]  Xenophon E. Verykios,et al.  Production of hydrogen for fuel cells by steam reforming of ethanol over supported noble metal catalysts , 2003 .

[20]  M. Caetano,et al.  Coupling and reforming of methane by means of low pressure radio-frequency plasmas , 2005 .

[21]  K. V. Kozlov,et al.  The barrier discharge: basic properties and applications to surface treatment , 2003 .

[22]  B. Ahn,et al.  Ni-based catalyst for partial oxidation reforming of iso-octane , 2004 .

[23]  B. Potapkin,et al.  Plasma-assisted production of hydrogen from hydrocarbons , 2002 .

[24]  Wen-Jhy Lee,et al.  Converting Methane by Using an RF Plasma Reactor , 1998 .

[25]  Shang-Chen Wu,et al.  Investigation on the production of hydrogen rich gas in a plasma converter for motorcycle applications , 2006 .

[26]  P. Irving,et al.  Steam Reforming of Hydrocarbon Fuels , 2002 .

[27]  D. R. Cohn,et al.  Plasma Reforming of Methane , 1998 .

[28]  Andrew E. Lutz,et al.  Thermodynamic analysis of hydrogen production by partial oxidation reforming , 2004 .

[29]  Eiji Suzuki,et al.  Selective Oxidation of Methane Using a Non-Thermal Pulsed Plasma , 2000 .

[30]  Thierry Paulmier,et al.  Use of non-thermal plasma for hydrocarbon reforming , 2005 .

[31]  Norbert Kaiser,et al.  Surface modification of PMMA by DC glow discharge and microwave plasma treatment for the improvement of coating adhesion , 2001 .

[32]  J. Han,et al.  New continuous gas-phase synthesis of high purity carbon nanotubes by a thermal plasma jet , 2004 .

[33]  Malcolm L. H. Green,et al.  Partial oxidation of methane to synthesis gas , 1990 .

[34]  Guillaume Petitpas,et al.  A comparative study of non-thermal plasma assisted reforming technologies , 2007 .

[35]  R. Gorte,et al.  A study of steam reforming of hydrocarbon fuels on Pd/ceria , 2002 .

[36]  Mariagiovanna Minutillo,et al.  Performance of a spark ignition engine fuelled with reformate gas produced on-board vehicle , 2007 .