Shear wave velocities and anisotropy in the Barbados accretionary complex

S wave velocities at the base of the Barbados accretionary wedge were determined from mode-converted S waves in two vertical seismic profiles in Ocean Drilling Program boreholes. At Hole 949C the profile extends from 92 to 397 m below seafloor (mbsf), ending ∼17 m into the decollement zone separating the wedge from the underthrust sediment on the subducting plate beneath. At Hole 948D the profile extends from 105 to 471 mbsf, ending ∼19 m above the decollement zone. S wave velocities are 303–549 m/s at Hole 949C and 453–679 m/s at Hole 948D. The profiles show that the lowest 70 m of the accreted sediment, just above the decollement, has lower S wave velocity (379±26 m/s at Hole 949C and 453±11 m/s at Hole 948D) and higher ratio of P wave to S wave velocity (Vp/Vs) (4.59±0.31 at Hole 949C and 3.99±0.10 at Hole 948D) than in the overlying layer. This coincides with high clay content that has a high proportion of smectite. Shear wave splitting observed in records from the lowest 100 m of the accretionary wedge at both sites indicates little or no anisotropy in the low-velocity zone. A single measurement at Hole 949C of the horizontal component of polarization of the leading split S wave from an ocean bottom shot is N68°E±20°. At Hole 949C, split shear wave delays in the downward propagating S wave originating at a fault at 275 mbsf indicate strong anisotropy in the range 275–306 mbsf and little or no anisotropy in the range 306–380 mbsf. The rate of increase of delay between 275 and 306 mbsf, 0.52±0.16 ms/m, can be modeled by either a Hudson cracked medium with crack density 0.186±0.054 or (preferably) a Hornby model of shale with 44% of clay particles aligned within 5° of the symmetry plane. This strong anisotropy is attributed to “scaly fabric,” alignment of clay particles by pervasive shear in the fault zone, which is observed in core. The low anisotropy in the remainder of the section shows that there is very little overall alignment of pore space in the lower part of the accreted sediments, supporting the hypothesis that the sediments are undercompacted rather than hydrofractured. The low S wave velocities and high Vp/Vs ratios indicate undercompaction and low effective stress despite the tectonic burial of the lowermost accreted sediments.

[1]  Philip H. Stauffer,et al.  Consolidation patterns during initiation and evolution of a plate-boundary decollement zone: Northern Barbados accretionary prism , 1998 .

[2]  T. Dixon,et al.  Relative motion between the Caribbean and North American plates and related boundary zone deformation from a decade of GPS observations , 1998 .

[3]  Stuart Crampin,et al.  Modelling the compliance of crustal rock—I. Response of shear‐wave splitting to differential stress , 1997 .

[4]  K. Brown,et al.  Porosity corrections for smectite-rich sediments: Impact on studies of compaction, fluid generation, and tectonic history , 1996 .

[5]  G. Nolet,et al.  Waveform analysis of Scholte modes in ocean sediment layers , 1996 .

[6]  D. Dewhurst,et al.  Fabric and hydraulic conductivity of sheared clays , 1996 .

[7]  Andrew T. Fisher,et al.  Relation between permeability and effective stress along a plate-boundary fault, Barbados accretionary complex , 1996 .

[8]  John A. Hudson,et al.  Anisotropic effective‐medium modeling of the elastic properties of shales , 1994 .

[9]  P. Stoffa,et al.  Seismically inferred dilatancy distribution, northern Barbados Ridge decollement: Implications for fluid migration and fault strength , 1994 .

[10]  Kevin M. Brown,et al.  Heterogeneous hydrofracture development and accretionary fault dynamics , 1994 .

[11]  R. Whitmarsh,et al.  A technique for conducting seismic refraction experiments on the ocean bed using bottom shots , 1991, Marine Geophysical Researches.

[12]  G. Westbrook,et al.  Cross section of an accretionary wedge: Barbados Ridge complex , 1988 .

[13]  J. Hudson.  A higher order approximation to the wave propagation constants for a cracked solid , 1986 .

[14]  J. Castagna,et al.  Relationships between compressional‐wave and shear‐wave velocities in clastic silicate rocks , 1985 .

[15]  G. K. Westbrook,et al.  Long decollements and mud volcanoes: Evidence from the Barbados Ridge Complex for the role of high pore-fluid pressure in the development of an accretionary complex , 1983 .

[16]  G. Westbrook.  The Structure of the Crust and Upper Mantle in the Region of Barbados and the Lesser Antilles , 1975 .

[17]  K. Moran,et al.  Directional Properties of P-wave Velocities and Acoustic Anisotropy in Different Structural Domains of the Northern Barbados Ridge Accretionary Prism Complex , 1998 .

[18]  J. Moore,et al.  17. ESTIMATED FLUID PRESSURES OF THE BARBADOS ACCRETIONARY PRISM AND ADJACENT SEDIMENTS 1 , 1997 .

[19]  M. Underwood,et al.  1. CLAY MINERALOGY AND CLAY GEOCHEMISTRY IN THE VICINITY OF THE DÉCOLLEMENT ZONE, NORTHERN BARBADOS RIDGE 1 , 1997 .

[20]  G. Westbrook,et al.  21. SEISMIC VELOCITIES IN THE NORTHERN BARBADOS RIDGE ACCRETIONARY COMPLEX, SITE 949 1 , 1997 .

[21]  K. Moran,et al.  Permeability and consolidation characteristics from Hole 949B, Northern Barbados Ridge , 1997 .

[22]  G. Moore,et al.  20. INTEGRATION OF VERTICAL SEISMIC PROFILING, LOGGING, AND SEISMIC DATA IN THE VICINITY OF THE DÉCOLLEMENT, NORTHERN BARBADOS RIDGE ACCRETIONARY PRISM 1 , 1997 .

[23]  N. Bangs,et al.  Structural setting of the Leg 156 area, northern Barbados Ridge acretionary prism , 1995 .

[24]  J. Moore,et al.  22. LABORATORY MEASUREMENT OF VELOCITY VS. EFFECTIVE STRESS IN THRUST FAULTS OF THE OREGON ACCRETIONARY PRISM: IMPLICATIONS FOR FAULT ZONE OVERPRESSURE1 , 1995 .

[25]  L. Dorman,et al.  Shear Wave Velocity Structure from Interface Waves at Two Deep Water Sites in the Pacific Ocean , 1991 .

[26]  R. Wilkens,et al.  20. DIAGENESIS AND DEWATERING OF CLAY-RICH SEDIMENTS, BARBADOS ACCRETIONARY PRISM 1 , 1990 .

[27]  H. Chamley,et al.  6. CLAY MINERALOGY OF SITES 671 AND 672, BARBADOS RIDGE ACCRETIONARY COMPLEX AND ATLANTIC ABYSSAL PLAIN: PALEOENVIRONMENTAL AND DIAGENETIC IMPLICATIONS1 , 1990 .

[28]  M. Zoback,et al.  Empirical relationships among seismic velocity, effective pressure, porosity, and clay content in sandstone , 1989 .

[29]  Stuart Crampin,et al.  Evaluation of anisotropy by shear‐wave splitting , 1985 .

[30]  F. Hron,et al.  Reflection and transmission coefficients for seismic waves in ellipsoidally anisotropic media , 1979 .