Development of a graded W/CuCrZr divertor for DEMO reactor
暂无分享，去创建一个
[1] M. Merola,et al. Critical heat flux analysis and R&D for the design of the ITER divertor , 1999 .
[2] C. Baxi. Thermal hydraulics of water cooled divertors , 2001 .
[3] R. Neu,et al. Tungsten as plasma-facing material in ASDEX Upgrade , 2003 .
[4] B. Riccardi,et al. Fatigue lifetime of repaired high heat flux components for ITER divertor , 2011 .
[5] B. Riccardi,et al. Recent development toward the use of infrared thermography as a non destructive technique for defect detection in tungsten plasma facing components , 2011 .
[6] J. Aktaa,et al. Numerical assessment of functionally graded tungsten/steel joints for divertor applications , 2011 .
[7] C. Hernandez,et al. Non-destructive examination of the bonding interface in DEMO divertor fingers , 2013 .
[8] Eliseo Visca,et al. Potential and limits of water cooled divertor concepts based on monoblock design as possible candidates for a DEMO reactor , 2013 .
[9] J. You,et al. Interpretation of the deep cracking phenomenon of tungsten monoblock targets observed in high-heat-flux fatigue tests at 20 MW/m2 , 2015 .
[10] J.-H. You,et al. European DEMO divertor target: Operational requirements and material-design interface , 2016 .
[11] E. Werner,et al. Low cycle fatigue behavior of ITER-like divertor target under DEMO-relevant operation conditions , 2015 .
[12] Jeong-Ha You,et al. Progress in the initial design activities for the European DEMO divertor , 2017 .